Comparative Analysis of HPDC Process of an Auto Part with ProCAST and FLOW-3D
Authors:
- 14 June 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 184-185, 90-94
Abstract
The high pressure die casting (HPDC) process of an ADC12 aluminum alloy auto part is researched by the software ProCAST and FLOW-3D, respectively. The possible HPDC defects of the auto part are analyzed. The difference of the filling process with the same technological parameter is studied. Compared with the simulation result of ProCAST, FLOW-3D software simulation result is closer to the die casting of the actual production.Keywords
This publication has 3 references indexed in Scilit:
- An intelligent system for predicting HPDC process variables in interactive environmentJournal of Materials Processing Technology, 2008
- Effect of Substrate Roughness on Splatting Behavior of HVOF Sprayed Polymer Particles: Modeling and ExperimentsJournal of Thermal Spray Technology, 2006
- Simulation-based selection of optimum pressure die-casting process parameters using neural nets and genetic algorithmsThe International Journal of Advanced Manufacturing Technology, 2005