Fabrication of high-performance on-chip suspended spiral inductors by micromachining and electroless copper plating
Authors:
- Y. WangYWY. Wang
- J.-L.A. YehJYJ.-L.A. Yeh
- N.C. TienNTN.C. Tien
- 7 November 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 279-282
Abstract
[[abstract]]Polysilicon spiral inductors encapsulated with copper (Cu) were suspended over 30-μm-deep cavities in the silicon substrate beneath. The metallization process simultaneously coated the inner surfaces of the cavities with Cu to form both good radio-frequency (RF) ground and electromagnetic shield. Quality factor (Q) up to 30 and self-resonance frequency (fres) higher than 10 GHz were achieved for a 10.4 nH inductor. Simulation showed that the Cu-lined cavities reduced the mutual inductance between two adjacent inductors by a factor of 5, compared with that without the cavities. This proves that good shielding was provided by the cavities[[fileno]]2020501030002[[department]]動機Keywords
This publication has 6 references indexed in Scilit:
- A novel buried oxide isolation for monolithic RF inductors on silicon2002
- Progress in RF inductors on silicon-understanding substrate losses2002
- Future directions in silicon ICs for RF personal communications2002
- New fabrication method for high-Q on-chip spiral inductor1999
- High Q inductors for wireless applications in a complementary silicon bipolar processIEEE Journal of Solid-State Circuits, 1996
- Silicon as a mechanical materialProceedings of the IEEE, 1982