Work Hardening Behavior of Ultrafine Grained Duplex Medium‐Mn Steels Processed by ART‐Annealing
Authors:
- 16 March 2012
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 83 (4) , 316-321
Abstract
The ultrafine grained duplex steels were fabricated by austenite reverted transformation annealing of the medium manganese steels after quenching or cold rolling. The microstructures were examined by scanning electron microscopy (SEM) and transmission electron microscopy (TEM) and X‐ray diffraction (XRD). The mechanical properties were determined by uniaxial tensile test. It was demonstrated that both the quenched and cold rolled structures were transformed into ultrafine grained duplex structures with large fractioned austenite by ART‐annealing. Long time annealing is essential to obtain the large fractioned austenite in quenched steel, but only short time annealing is needed to get large fractioned austenite in the cold rolled sheet. The mechanical examinations indicated that ART‐annealing results in the superhigh tensile elongation (>40%) and superhigh strength (1000 MPa) in quenched steels after long time annealing but in cold rolled steels after short time annealing. Based on the analysis on the work hardening behaviors of these ART‐annealed steels, the abnormal work hardening rate was presented and analyzed. The substantially enhanced ductility was attributed to the Lüders band propagation of the ferrite matrix and/or the TRIP effects of the large fractioned austenite. At last the dynamic phase natures of both fraction and stress was proposed to interpret the abnormal hardening behaviors and the “S” shaped stress–strain curves.Keywords
This publication has 17 references indexed in Scilit:
- Experimental and numerical analysis on formation of stable austenite during the intercritical annealing of 5Mn steelActa Materialia, 2011
- Design method for TRIP-aided multiphase steel based on a microstructure-based modelling for transformation-induced plasticity and mechanically induced martensitic transformationMaterials Science and Engineering: A, 2009
- An EBSD investigation of interstitial-free steel subjected to equal channel angular extrusionMaterials Science and Engineering: A, 2008
- Transformation-induced plasticity in an ultrafine-grained steel: An in situ neutron diffraction studyApplied Physics Letters, 2007
- Microstructure and Formability of Aluminum Bearing TRIP-Aided Steels with Annealed Martensite MatrixISIJ International, 2005
- Supra-Ductile and High-Strength Manganese-TRIP/TWIP Steels for High Energy Absorption Purposes.ISIJ International, 2003
- On the sources of work hardening in multiphase steels assisted by transformation-induced plasticityPhilosophical Magazine A, 2001
- Retained Austenite Characteristics and Tensile Properties in a TRIP Type Bainitic Sheet Steel.ISIJ International, 2000
- Thermal processing of ferritic 5Mn steel for toughness at cryogenic temperaturesMetallurgical Transactions A, 1980
- Ultrafine-grained microstructures and mechanical properties of alloy steelsMetallurgical Transactions, 1972