CFD aided finite element modeling for spot cooled vibration assisted turning of Ti6Al4V alloy
- 12 September 2024
- journal article
- research article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 28 (5) , 1-30
Abstract
No abstract availableKeywords
This publication has 44 references indexed in Scilit:
- Role of jet radius and jet location in cryogenic machining of Inconel 718: a finite element method based approachInternational Journal on Interactive Design and Manufacturing (IJIDeM), 2020
- FE Modeling and Experimental Analysis of Residual Stresses in Vibration Assisted Turning of Ti6Al4VInternational Journal of Precision Engineering and Manufacturing, 2019
- Prediction of temperature distribution over cutting tool with alumina-MWCNT hybrid nanofluid using computational fluid dynamics (CFD) analysisThe International Journal of Advanced Manufacturing Technology, 2018
- A numerical and experimental study to investigate convective heat transfer and associated cutting temperature distribution in single point turningThe International Journal of Advanced Manufacturing Technology, 2017
- Analyzing machining parameters for commercially puretitanium (Grade 2), cooled using minimum quantity lubrication assisted by a Ranque-Hilsch vortex tubeThe International Journal of Advanced Manufacturing Technology, 2016
- An experimental investigation on effect of minimum quantity cooling lubrication (MQCL) in machining titanium alloy (Ti6Al4V)The International Journal of Advanced Manufacturing Technology, 2016
- Numerical modelling and analysis of the influence of an air cooling system on a milling machine in virtual environmentThe International Journal of Advanced Manufacturing Technology, 2016
- A novel numerical modeling approach to determine the temperature distribution in the cutting tool using conjugate heat transfer (CHT) analysisThe International Journal of Advanced Manufacturing Technology, 2015
- Finite element simulation and experimental investigation of tool temperature during ultrasonically assisted turning of aerospace aluminum using multicoated carbide insertsThe International Journal of Advanced Manufacturing Technology, 2014
- Problems and solutions in machining of titanium alloysThe International Journal of Advanced Manufacturing Technology, 2013