Effect of Ionic Strength on Initial Interactions of Escherichia coli with Surfaces, Studied On-Line by a Novel Quartz Crystal Microbalance Technique
- 1 September 1999
- journal article
- research article
- Published by American Society for Microbiology in Journal of Bacteriology
- Vol. 181 (17) , 5210-5218
Abstract
A novel quartz crystal microbalance (QCM) technique was used to study the adhesion of nonfimbriated and fimbriated Escherichia coli mutant strains to hydrophilic and hydrophobic surfaces at different ionic strengths. This technique enabled us to measure both frequency shifts (Δ f ), i.e., the increase in mass on the surface, and dissipation shifts (Δ D ), i.e., the viscoelastic energy losses on the surface. Changes in the parameters measured by the extended QCM technique reflect the dynamic character of the adhesion process. We were able to show clear differences in the viscoelastic behavior of fimbriated and nonfimbriated cells attached to surfaces. The interactions between bacterial cells and quartz crystal surfaces at various ionic strengths followed different trends, depending on the cell surface structures in direct contact with the surface. While Δ f and Δ D per attached cell increased for nonfimbriated cells with increasing ionic strengths (particularly on hydrophobic surfaces), the adhesion of the fimbriated strain caused only low-level frequency and dissipation shifts on both kinds of surfaces at all ionic strengths tested. We propose that nonfimbriated cells may get better contact with increasing ionic strengths due to an increased area of contact between the cell and the surface, whereas fimbriated cells seem to have a flexible contact with the surface at all ionic strengths tested. The area of contact between fimbriated cells and the surface does not increase with increasing ionic strengths, but on hydrophobic surfaces each contact point seems to contribute relatively more to the total energy loss. Independent of ionic strength, attached cells undergo time-dependent interactions with the surface leading to increased contact area and viscoelastic losses per cell, which may be due to the establishment of a more intimate contact between the cell and the surface. Hence, the extended QCM technique provides new qualitative information about the direct contact of bacterial cells to surfaces and the adhesion mechanisms involved.Keywords
This publication has 44 references indexed in Scilit:
- Energy Dissipation Kinetics for Protein and Antibody−Antigen Adsorption under Shear Oscillation on a Quartz Crystal MicrobalanceLangmuir, 1998
- Model of quartz crystal microbe growth sensor and its application to estimation of microbial populations in mineral watersAnalytica Chimica Acta, 1996
- QCM Operation in Liquids: An Explanation of Measured Variations in Frequency and Q Factor with Liquid ConductivityAnalytical Chemistry, 1996
- In situ continuous detection of bacteria on the surface of solid medium with a Bulk Acoustic Wave-Impedance SensorJournal of Microbiological Methods, 1996
- Linker insertion analysis of the FimH adhesin of type 1 fimbriae in anEscherichia coli fimH-null backgroundFEMS Microbiology Letters, 1996
- Determination of microorganisms with a quartz crystal microbalance sensorAnalytica Chimica Acta, 1996
- On line, non-destructive biomass determiantion of bacterial biofilms by fluorometryJournal of Microbiological Methods, 1993
- Monitoring microbiol adhesion and biofilm formation by attenuated total reflection/Fourier transform infrared spectroscopyJournal of Microbiological Methods, 1993
- Verwendung von Schwingquarzen zur W gung d nner Schichten und zur Mikrow gungThe European Physical Journal A, 1959
- Electrophoresis and phage susceptibility studies on a filament-producing variant of the E. coli B bacteriumBiochimica et Biophysica Acta, 1954