Resorption Thermal Transformer Generator Design
Open Access
Abstract
This work takes an empirical and evidence-based approach in the development of a resorption thermal transformer. It presents the initial modelling conducted to understand key performance parameters (coefficient of performance and specific mean power) before discussing a preliminary design. Experimental results from large temperature jump and isosteric heating tests have identified the importance of heat transfer in ammonia-salt systems. Both the heat transfer resistance between the salt composite adsorbent and the tube side wall, and the heat transfer from the heat transfer fluid to the tube side wall are key to realising resorption systems. The successful performance of a laboratory-scale prototype will depend on the reduction in these heat transfer resistances, and improvements may be key in future prototype machines. A sorption reactor is sized and presented, which can be scaled for length depending on the desired power output. The reactor design presented was derived using data on reaction kinetics constants and heat of reaction for calcium chloride reacting with ammonia that were obtained experimentally. The data enabled accurate modelling to realise an optimised design of a reactor, focusing on key performance indicators such as the coefficient of performance (COP) and the system power density. This design presents a basis for a demonstrator that can be used to collect and publish dynamic data and to calculate a real COP for resorption system.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/V011316/1, EP/R045496/1)
- Innovate UK (Energy Research Accelerator)
This publication has 39 references indexed in Scilit:
- Novel ammonia sorbents ‘‘porous matrix modified by active salt” for adsorptive heat transformation: 6. The ways of adsorption dynamics enhancementApplied Thermal Engineering, 2012
- Optimal cycle selection in carbon-ammonia adsorption cyclesInternational Journal of Refrigeration, 2012
- Dynamics of BaCl2–NH3 adsorption pairApplied Thermal Engineering, 2009
- Resorption heat pumpApplied Thermal Engineering, 2004
- Experimental study on the kinetics of water vapor sorption on selective water sorbents, silica gel and alumina under typical operating conditions of sorption heat pumpsInternational Journal of Heat and Mass Transfer, 2003
- Modelling and experimental investigation of a new type of thermochemical transformer based on the coupling of two solid-gas reactionsChemical Engineering and Processing - Process Intensification, 1994
- ANALYSIS OF HEAT TRANSFER IN A NON-ISOTHERMAL SOLID-GAS REACTING MEDIUMChemical Engineering Communications, 1991
- ANALYSIS AND EXPERIMENTAL STUDY OF THE TRANSFORMATION OF A NON-ISOTHERMAL SOLID/GAS REACTING MEDIUMChemical Engineering Communications, 1991
- Simulation for the development of solid—gas chemical heat pump pilot plants Part II. simulation and optimization of Discontinuous and pseudo-continuous operating cyclesChemical Engineering and Processing - Process Intensification, 1990
- Simulation for the development of solid—gas chemical heat pump pilot plants Part I. simulation and dimensioningChemical Engineering and Processing - Process Intensification, 1990