Air‐water interfacial areas in unsaturated soils: Evaluation of interfacial domains
Authors:
Open Access
- 16 October 2002
- journal article
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 38 (10) , 13-1-13-17
Abstract
A gas‐phase miscible‐displacement method, using decane as an interfacial tracer, was used to measure air‐water interfacial areas for a sand with water contents ranging from ∼2% to 20%. The expected trend of decreasing interfacial areas with increasing water contents was observed. The maximum estimated interfacial area of 19,500 cm−1 appears reasonable given it is smaller than the measured surface area of the porous medium (60,888 cm−1). Comparison of the experimental data presented herein with literature data provided further insight into the characterization of the air‐water interface in unsaturated porous media. Specifically, comparison of interfacial areas measured using gas‐phase versus aqueous‐phase methods indicates that the gas‐phase method generally yields larger interfacial areas than the aqueous‐phase methods, even when accounting for differences in water content and physical properties of the porous media. The observations are consistent with proposed differences in interfacial accessibility of the aqueous‐ and gas‐phase tracers. Evaluation of the data in light of functional interfacial domains, described herein, yields the hypothesis that aqueous interfacial tracers measure primarily air‐water interfaces formed by “capillary water,” while gas‐phase tracers measure air‐water interfaces formed by both capillary and surface‐adsorbed (film) water. The gas‐ and aqueous‐phase methods may each provide interfacial area information that is more relevant to specific problems of interest. For example, gas‐phase interfacial area measurements may be most relevant to contaminant transport in unsaturated systems, where retention at the air‐water interface may be significant. Conversely, the aqueous‐phase methods may yield information with direct bearing on multiphase flow processes that are dominated by capillary‐phase behavior.Keywords
This publication has 26 references indexed in Scilit:
- A method for determining air–water interfacial area in variably saturated porous mediaJournal of Contaminant Hydrology, 2000
- Contaminant Vapor Adsorption at the Gas−Water Interface in SoilsEnvironmental Science & Technology, 1999
- Estimating interfacial areas for multi-fluid soil systemsJournal of Contaminant Hydrology, 1997
- Characterizing Gas−Water Interfacial and Bulk-Water Partitioning for Gas-Phase Transport of Organic Contaminants in Unsaturated Porous MediaEnvironmental Science & Technology, 1997
- Estimating the surface area of fluid phase interfaces in porous mediaJournal of Contaminant Hydrology, 1994
- Partitioning of organic chemicals at the air-water interface in environmental systemsEnvironmental Science & Technology, 1993
- Water movement in "unsaturated" porous media due to pore size and surface tension induced capillary pressure gradientsLangmuir, 1993
- Pore scale spatial analysis of two immiscible fluids in porous mediaWater Resources Research, 1991
- Structural properties of packed beds — A reviewThe Canadian Journal of Chemical Engineering, 1969
- Preferential Capillary Adsorption of Water from Solutions of Alcohols by Silica GelThe Journal of Physical Chemistry, 1952