Nano-Enhanced Cactus Oil as an MQL Cutting Fluid: Physicochemical, Rheological, Tribological, and Machinability Insights into Machining H13 Steel
Open Access
- 15 June 2025
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 13 (6) , 267
Abstract
The widespread use of mineral cutting fluids in metalworking poses challenges due to their poor wettability, toxicity, and non-biodegradability. This study explores cactus oil-based nanofluids as sustainable alternatives for metal cutting applications. Samples of cactus oil are prepared in plain form and with 0.025 wt.%, 0.05 wt.%, and 0.1 wt.% activated carbon nanoparticles (ACNPs) from recycled plastic waste. Plain cactus oil exhibited a 34% improvement in wettability over commercial soluble oil, further enhanced by 60% with 0.05 wt.% ACNPs. Cactus oil displayed consistent Newtonian behavior with a high viscosity index (283), outperforming mineral-based cutting fluid in thermal stability. The addition of ACNPs enhanced the dynamic viscosity by 108–130% across the temperature range of 40–100 °C. The presence of nano-additives reduced the friction coefficient in the boundary lubrication zone by a maximum reduction of 32% for CO2 compared to plain cactus oil. The physical and rheological results translated directly to the observed improvements in surface finish and tool wear during machining operations on H13 steel. Cactus oil with 0.05 wt.% ACNP outperformed conventional fluids, reducing surface roughness by 35% and flank wear by 57% compared to dry. This work establishes cactus oil-based nanofluids as a sustainable alternative, combining recycled waste-derived additives and non-edible feedstock for greener manufacturing.Keywords
This publication has 69 references indexed in Scilit:
- Viscosity of graphene in lubricating oil, ethylene glycol and glycerolJournal of Thermal Analysis and Calorimetry, 2023
- Ti6Al4V grinding using different lubrication modes for minimizing energy consumptionThe International Journal of Advanced Manufacturing Technology, 2023
- On the Elastohydrodynamic Film-Forming Properties of Metalworking Fluids and Oil-in-Water EmulsionsTribology Letters, 2022
- Synthesis of environment‐friendly, sustainable, and nontoxic bio‐lubricants: A critical review of advances and a path forwardBiofuels, Bioproducts and Biorefining, 2022
- Circulating purification of cutting fluid: an overviewThe International Journal of Advanced Manufacturing Technology, 2021
- Physicochemical properties of degradable vegetable-based oils on minimum quantity lubrication millingThe International Journal of Advanced Manufacturing Technology, 2020
- Experimental evaluation of the lubrication performances of different nanofluids for minimum quantity lubrication (MQL) in milling Ti-6Al-4VThe International Journal of Advanced Manufacturing Technology, 2018
- Comparative Chemical Composition and Bioactivity of Opuntia ficus‐indica Sanguigna and Surfarina Seed Oils Obtained by Traditional and Ultrasound‐Assisted Extraction ProceduresEuropean Journal of Lipid Science and Technology, 2018
- An optimization method of the machining parameters in high-speed machining of stainless steel using coated carbide tool for best surface finishThe International Journal of Advanced Manufacturing Technology, 2011
- Characterization of Opuntia ficus indica seed oil from TunisiaChemistry of Natural Compounds, 2009