Design and Development of Solar Power Hybrid Electric Vehicles Charging Station
Authors:
- 5 September 2020
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 285-289
Abstract
In this paper design and development of a Hybrid charging station for electric vehicles is discussed. The charging station is powered by a combination of solar power and grid power. The system works in an integrated way to optimize the energy use from the grid. The system will take the power from solar arrays and directly charge the EV when solar energy is available. When solar energy is not available the system will be powered by the grid. In addition, the system will also deliver the solar power to grid when solar power is available but there is no EV is connected to the charging system. In this mode, the charging station will work as a grid connected solar power plant. Generally, a transformer is used for feeding the low voltage solar power to the grid, whereas in this work a advance high gain boost converter is used to eliminate the transformer. This modification considerably reduces the overall system cost and size. Extensive simulation results are present in this paper to establish the effectiveness of the developed hybrid charging stations.Keywords
This publication has 9 references indexed in Scilit:
- Bi-level charging station planning for integrated power distribution and transportation system2017
- Solar grid-tied inverter, with battery back-up, for efficient solar energy harvesting2016
- Design of charge controller for solar PV systems2015
- Modeling and protection of electric vehicle charging station2014
- EV charging stations and modes: International standards2014
- Power maximization of a photovoltaic system using automatic solar panel tracking along with boost converter and charge controller2012
- Design and development of a grid tied solar inverter2012
- Perturb and observe MPPT algorithm for solar PV systems-modeling and simulation2011
- A High Gain Transformer-Less DC-DC Converter for Fuel-Cell Applications2006