Experimental and Modeling Study of a Diesel Oxidation Catalyst (DOC) under Transient and CPF Active Regeneration Conditions
Authors:
- 8 April 2013
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
In this study, a DOC catalyst was experimentally studied in an engine test cell with a2010 Cummins 6.7L ISB diesel and a production aftertreatment system. The test matrix consisted of steady state, active regeneration with in-cylinder fuel dosing and transient conditions. Conversion efficiencies of total hydrocarbon (THC), CO, and NO were quantified under each condition.A previously developed high-fidelity DOC model capable of predicting both steady state and transient active regeneration gaseous emissions was calibrated to the experimental data. The model consists of a single 1D channel where mass and energy balance equations were solved for both surface and bulk gas regions. The steady-state data were used to identify the activation energies and pre-exponential factors for CO, NO and HC oxidation, while the steady-state active regeneration data were used to identify the inhibition factors. The transient data were used to simulate the thermal response of the DOC. A calibration procedure was developed and the identified model parameters are presented.The performance of the model was compared to the experimental results in terms of the outlet NO2/NOx ratios and CO, HC conversion efficiencies. The results show that the model is able to simulate the DOC performance under steady-state and transient conditions and during active regeneration conditions. The model is able to predict the outlet temperatures and HC concentrations within the measurement uncertainties. An inhibition factor that accounts for the inhibition of reactions in the presence of high hydrocarbon concentrations was determined so that the outlet HC and NO2 concentrations during active regeneration were simulated accurately.Keywords
This publication has 12 references indexed in Scilit:
- A Kalman Filter estimator for a Diesel Oxidation Catalyst during active regeneration of a CPF2012
- Deactivation of Cu/Zeolite SCR Catalyst under Lean-Rich Aging ConditionsSAE International Journal of Advances and Current Practices in Mobility, 2010
- Engine Test for DOC Quenching in DOC-DPF System for Non-Road ApplicationsSAE International Journal of Fuels and Lubricants, 2010
- Diesel oxidation catalyst and particulate filter modeling in active – Flow configurationsApplied Thermal Engineering, 2009
- Numerical Simulation of DOC+DPF+SCR systems:DOC Influence on SCR PerformanceSAE International Journal of Fuels and Lubricants, 2008
- Aged DOC is a Net Consumer of NO2: Analyses of Vehicle, Engine-dynamometer and Reactor DataSAE International Journal of Advances and Current Practices in Mobility, 2007
- Global Kinetics for Platinum Diesel Oxidation CatalystsIndustrial & Engineering Chemistry Research, 2007
- Comparison of Diesel Oxidation Catalyst Performance on an Engine and a Gas Flow ReactorSAE International Journal of Advances and Current Practices in Mobility, 2007
- Characterizing Light-Off Behavior and Species-Resolved Conversion Efficiencies During In-Situ Diesel Oxidation Catalyst DegreeningSAE International Journal of Advances and Current Practices in Mobility, 2006
- Monolithic reactors: mass transfer measurements under reacting conditionsChemical Engineering Science, 1992