Tribological investigation of the new combustion chamber with wall-guided fuel injection in a diesel engine
- 29 August 2024
- journal article
- research article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 26 (1) , 27-40
Abstract
Reducing pollutants and increasing thermal efficiency in internal combustion engines is possible by creating better air-fuel mixtures and optimizing the combustion process. In this context, a new combustion chamber providing directed fuel injection was used in a single cylinder diesel engine with a standard combustion chamber. Thus, it was aimed to investigate the tribological behavior of engines with different combustion chambers on long-term engine operation. In engine experiments using two different combustion chambers, the engine was operated at 100 h and partial load. The results of the study showed that changes in combustion chamber structure closely modify engine tribology under the same engine and operating conditions (compression ratio, spray angle and amount, speed, etc.). Looking at the cylinder surfaces examined under an optical microscope, the new combustion chamber showed abrasive wear lines with lower intensity than the standard combustion chamber, while SEM/EDX analysis of the piston ring surfaces showed a similar result. Especially when the analysis of the second ring used in the standard combustion chamber is examined, abrasion occurred in a wider area. Abrasive wear lines were found to be longer, especially in the first ring of the new combustion chamber. It is considered that combustion parameters and exhaust formation processes bring about load/temperature variations of engine lubricating oil and engine components in a chain reaction. This has been found to change the wear levels in engine components and could directly contribute to engine life.Keywords
Funding Information
- Ulusal Metroloji Enstitüsü, Türkiye Bilimsel ve Teknolojik Araştirma Kurumu (120M143)
This publication has 19 references indexed in Scilit:
- Experimental investigation of tribo-corrosion and engine characteristics of Aegle Marmelos Correa biodiesel and its diesel blends on direct injection diesel engineEnergy, 2019
- The combustion and emission characteristics of a multi-swirl combustion system in a DI diesel engineApplied Thermal Engineering, 2017
- Effects of biodiesel blends on lubricating oil degradation and piston assembly energy lossesEnergy, 2016
- Effect of pongamia oil methyl ester–diesel blend on lubricating oil degradation of di compression ignition engineFuel, 2016
- Numerical investigation of piston bowl geometry and swirl ratio on emission from diesel enginesEnergy Conversion and Management, 2015
- Experimental investigations of effect of Karanja biodiesel on tribological properties of lubricating oil in a compression ignition engineFuel, 2014
- Investigation of friction and wear characteristics of palm biodieselEnergy Conversion and Management, 2013
- Influences of re-entrant combustion chamber geometry on the performance of Pongamia biodiesel in a DI diesel engineEnergy, 2012
- Investigation of variations of lubricating oil diluted by post-injected fuel for the regeneration of CDPF and its effects on engine wearJournal of Mechanical Science and Technology, 2008
- CFD modeling of the in-cylinder flow in direct-injection Diesel enginesComputers & Fluids, 2004