Allowable Surface Durability in Grease Lubricated Gears
Author:
- 1 January 1988
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 31 (4) , 454-460
Abstract
Experimental results are presented for grease lubricated gears. First, the oil-film formations were measured, using a power circulating gear machine. The same tests were also performed with gear oils. The oil-film formation for grease was unstable compared to oil. The results show that the normal load at which the oil-film formation of grease becomes insufficient was about 60 percent of that for oil. In addition, a life test was carried out. Surface damage of gear teeth was scoring rather than spalling. The gear life was closely related to the normal load. The results were also compared with AGMA standards. It was suggested that the allowable surface durability of a grease lubricated gear was 0.9 GPa in hertzian Pressure which was about 60 percent that of an oil lubricated gear. The data were then used to develop a design for grease lubricated gears.Keywords
This publication has 7 references indexed in Scilit:
- Wear of gear of circular-arc tooth-profile: effect of helix angle and oil viscosityTribology International, 1987
- Load-carrying capacity of the HB.IMAGE.340 (hardened and tempered) gears. (6th report. Influence of hardness combination of gear pairs on their surface durabilities - Gear pairs with the same surface finish).TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 1987
- Investigation on Dynamic Oil-Fil-Formation and Pitting in Spur Gear : 1st Report, Oil-Film-Fotmatidn in the Case of Gear Ratio 1/1Transactions of the Japan Society of Mechanical Engineers, 1978
- EHD Lubricant Film Thickness Formulas for Power Transmission GearsJournal of Lubrication Technology, 1974
- An Experimental Study of Grease in Elastohydrodynamic LubricationJournal of Lubrication Technology, 1972
- The Measurement of Oil-Film Thickness in Gear TeethJournal of Basic Engineering, 1960
- A study of the oil-film formation in gears by electrical resistance measurementsBritish Journal of Applied Physics, 1952