Evaluating three calibration transfer methods for predictions of soil properties using mid‐infrared spectroscopy
- 29 January 2021
- journal article
- research article
- Published by Wiley in Soil Science Society of America Journal
- Vol. 85 (3) , 501-519
Abstract
Mid‐infrared (MIR) spectroscopy models have been developed for rapid assessment of soils but are often soil and instrument specific because of differences in laboratory conditions and sensor setup. Calibration transfer is required to apply a spectral model such as partial least squares (PLS) regression developed from a primary instrument to a spectral dataset measured by a secondary instrument with statistically retained accuracy and precision. The study aimed to compare the performance of three transfer methods (i.e., direct standardization [DS], piecewise direct standardization [PDS], and spectral space transfer [SST]) and investigate the effects of transfer sample size and sample selection methods. The transfer methods were developed for predicting total C, clay, silt, and sand contents, cation exchange capacity (CEC), pH in water (pH W ) and CaCl 2 , CaCO 3 equivalent, and −1,500‐kPa water retention using spectral measurements of a secondary instrument. Calibration transfer methods of three PLS models for estimating soil properties with a high (total C), intermediate (clay content), and low (pH W ) predictability were discussed. The effect of sample size required for the development of the calibration transfer and the selection method of the transferred samples were investigated. It was found that SST was most favorable for a relatively small sample size used in calibration transfer (≤12 samples). The performance of transfer methods was optimal when the transfer samples accounted for the variability of MIR spectra from the secondary instrument. We conclude that SST and PDS have the potential to be applied in spectroscopy for predicting soil properties using secondary instruments.Keywords
This publication has 51 references indexed in Scilit:
- Comparison of soil reflectance spectra and calibration models obtained using multiple spectrometersGeoderma, 2011
- Maintaining the predictive abilities of multivariate calibration models by spectral space transformationAnalytica Chimica Acta, 2011
- Preventing over‐fitting in PLS calibration models of near‐infrared (NIR) spectroscopy data using regression coefficientsJournal of Chemometrics, 2010
- Soil organic carbon prediction by hyperspectral remote sensing and field vis-NIR spectroscopy: An Australian case studyGeoderma, 2008
- Mid- and near-infrared spectroscopic assessment of soil compositional parameters and structural indices in two FerralsolsGeoderma, 2006
- Visible, near infrared, mid infrared or combined diffuse reflectance spectroscopy for simultaneous assessment of various soil propertiesGeoderma, 2006
- Effects of spatial variability and scale with implications to hydrologic modelingJournal of Hydrology, 1988
- Control Procedures for Residuals Associated With Principal Component AnalysisTechnometrics, 1979
- Validation of Regression Models: Methods and ExamplesTechnometrics, 1977
- Effects of spatial variability of soil hydraulic properties in water budget modelingWater Resources Research, 1977