Dynamic model of a plasticating extruder
Authors:
- 1 February 1974
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 14 (2) , 112-119
Abstract
A theoretical model for the simulation of dynamic operation of a plasticating extruder is proposed. The model can be recommended as a tool to study various dynamic situations of interest in the operation of an extruder. Several responses to changes in operating conditions are discussed. They indicate the occurrence of transient maximas and occasional oscillations. The controlling of flow rate by adjusting a valve at the die seems to cause temporary local high peaks in pressure, whereas its control through screw speed seems to be satisfactory.Keywords
This publication has 12 references indexed in Scilit:
- A mathematical model for predicting dynamic behavior of a plasticating extruderPolymer Engineering & Science, 1973
- Solids conveying in screw extruders part III: The delay zonePolymer Engineering & Science, 1972
- Solids conveying in screw extruders part II: Non isothermal modelPolymer Engineering & Science, 1972
- Solids conveying in screw extruders part I: A modified isothermal modelPolymer Engineering & Science, 1972
- The melting of a bed of polymer granules on a hot moving surfaceChemical Engineering Science, 1971
- The melting of a crystalline polymer in a screw extruderChemical Engineering Science, 1971
- A theoretical melting model for a reciprocating‐screw injection molding machinePolymer Engineering & Science, 1971
- A theoretical melting model for plasticating extrudersPolymer Engineering & Science, 1971
- Plasticating single‐screw extrusion theoryPolymer Engineering & Science, 1971
- A modified melting model for plastifying extrudersPolymer Engineering & Science, 1970