The Effect of Microstructure and Axial Tension on Three-Point Bending Fatigue Behavior of TC4 in High Cycle and Very High Cycle Regimes
Open Access
Abstract
The effects of microstructure and axial tension on the fatigue behavior of TC4 titanium alloy in high cycle (HCF) and very high cycle (VHCF) regimes are discussed in this paper. Ultrasonic three-point bending fatigue tests at 20 kHz were done on a fatigue life range among 105–109 cycles of the alloys with equiaxed, bimodal and Widmanstatten microstructures. Experimental results without axial tension show that three typical shapes of S-N curves clearly present themselves for the three different microstructures. Moreover, the crack initiation sites abruptly shifted from surface to subsurface of the specimen in the very high cycle fatigue regime for equiaxed and bimodal microstructures. But for the Widmanstatten microstructure, both surface and subsurface crack initiation appeared in the high cycle fatigue regime, and the multi-points crack initiation was found in the bimodal microstructure. The subsurface fatigue crack originated from the αp grains in equiaxed and bimodal microstructures. However, it originated from the coarse grain boundary α in the Widmanstatten microstructure. Additionally, the S-N curve shape, fatigue life and fatigue crack initiation mechanism with axial tension are similar to that without axial tension. However, the crack origin point shifts inward with axial tension.Keywords
Funding Information
- National Key Research and Development Program of China (2015CB057400)
This publication has 33 references indexed in Scilit:
- Fatigue strength and failure mechanisms of wrought aluminium alloys in the VHCF-region considering material and component relevant influencing factorsInternational Journal of Fatigue, 2011
- The effect of microstructure on very high cycle fatigue properties in Ti–6Al–4VScripta Materialia, 2010
- Statistical duplex S–N characteristics of high carbon chromium bearing steel in rotating bending in very high cycle regimeInternational Journal of Fatigue, 2010
- Competing failure modes and complex S–N curves in fatigue of structural materialsInternational Journal of Fatigue, 2010
- Microstructural Influences on Very-High-Cycle Fatigue-Crack Initiation in Ti-6246Metallurgical and Materials Transactions A, 2008
- Effect of microstructure on ultra-high cycle fatigue behavior of Ti–6Al–4VMaterials Science and Engineering: A, 2008
- Duality of the S–N fatigue curve caused by competing failure modes in a titanium alloy and the role of Poisson defect statisticsActa Materialia, 2005
- Very high cycle regime fatigue of thin walled tubes made from austenitic stainless steelFatigue & Fracture of Engineering Materials & Structures, 2002
- Local texture and fatigue crack initiation in a Ti‐6Al‐4V titanium alloyFatigue & Fracture of Engineering Materials & Structures, 2002
- An overview on the use of titanium in the aerospace industryMaterials Science and Engineering: A, 1996