Modeling a Low-Cost Frequency Selective Wall for Wireless-Friendly Indoor Environments
Authors:
- 17 July 2006
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 5 (15361225) , 311-314
Abstract
A simple, low-cost frequency selective (FS) wall which filters out a particular frequency with about 30 dB attenuation is constructed by covering an existing wall with a custom designed Frequency Selective Surface (FSS). With 10 mm air spacing between the FSS cover and the wall surface, independence between the two can be achieved. Under such a scenario, performance of the FS wall can be evaluated by cascading the FSS and the wall responses individually. Good agreement between the cascaded evaluation and the actual measured transmission response was foundKeywords
This publication has 5 references indexed in Scilit:
- Equivalent Circuit Modelling of a Frequency Selective Plasterboard Wall2005
- Designing buildings for the wireless ageComputing & Control Engineering Journal, 2004
- The impact of frequency selective surfaces applied to standard wall construction materials2004
- Equivalent circuit model for arrays of square loopsElectronics Letters, 1982
- A Survey of the Theory of Wire GridsIEEE Transactions on Microwave Theory and Techniques, 1962