Design and Optimization Method of Magnetic Bearing for High-Speed Motor Considering Eddy Current Effects
Authors:
- 17 May 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 21 (4) , 2061-2072
Abstract
With the development of the magnetic bearing (MB) and its application in industry, the demands of high-speed MB are developing, which bring up new problems and requirement for the design. The motor with a high-speed rigid rotor requires that the axial length of MB is minimized to increase the critical speed, and the diameter of thrust disk is minimized to reduce the air friction loss. Also because of the high speed, the eddy currents induced in the iron cores have a significant influence on the dynamic characteristics of the MB. To design a high-performance MB for a high-speed motor, first an MB structure that has the feature of short axial length and small thrust disk is recommended for the high-speed motor. Next, the dynamic model, which takes into consideration eddy current effects, and leakage effects is developed. Then, an optimal design method with multiobjective of minimum length and air friction loss is presented. Design constraints are imposed, which includes the simultaneous consideration of material properties, load capacity, and power amplifier. Finally, a design example is given and a prototype is manufactured. The experimental results demonstrate that the proposed MB structure and the optimization method are feasible and valid in the application of a high-speed motor.Keywords
Funding Information
- Beijing Natural Science Foundation (3164047)
- National Nature Science Funds of China (61573032)
This publication has 28 references indexed in Scilit:
- Nonlinear Model Analysis and “Switching Model” of AC–DC Three-Degree-of-Freedom Hybrid Magnetic BearingIEEE/ASME Transactions on Mechatronics, 2015
- The Design of the Simple Structure-Specified Controller of Magnetic Bearings for the High-Speed SRMIEEE/ASME Transactions on Mechatronics, 2014
- The Multiobjective Optimal Design of a Two-Degree-of-Freedom Hybrid Magnetic BearingIEEE Transactions on Magnetics, 2014
- Design and Optimization of a Radial Hybrid Magnetic Bearing With Separate Poles for Magnetically Suspended Inertially Stabilized PlatformIEEE Transactions on Magnetics, 2013
- Radially Biased Axial Magnetic Bearings/Motors for Precision Rotary-Axial SpindlesIEEE/ASME Transactions on Mechatronics, 2011
- Model Validation for an Active Magnetic Bearing Based Compressor Surge Control Test RigJournal of Vibration and Acoustics, 2010
- A New Structure for Permanent-Magnet-Biased Axial Hybrid Magnetic BearingsIEEE Transactions on Magnetics, 2009
- Modeling of Nonlaminated Electromagnetic Suspension SystemsIEEE/ASME Transactions on Mechatronics, 2009
- Analysis of hybrid magnetic bearing with a permanent magnet in the rotor by FEMIEEE Transactions on Magnetics, 2006
- An augmented circuit model for magnetic bearings including eddy currents, fringing, and leakageIEEE Transactions on Magnetics, 1996