Use of life and strain fraction rules for creep life prediction of pressurized pipe components undergoing geometry change
- 1 May 2005
- journal article
- research article
- Published by SAGE Publications in The Journal of Strain Analysis for Engineering Design
- Vol. 40 (4) , 385-394
Abstract
The results of creep failure life predictions of pressurized plain pipes, pipe bends, and a thick-walled pipe with a circumferential weld are used to demonstrate the applicability of a stress-based life fraction rule (LFR) and a strain-based strain fraction rule (SFR), under conditions of geometric non-linearity (GNL). The material properties used are related to a CrMoV pipe, at 640°C. Both the LFR and the SFR predictions are based on the stress and strain solutions obtained from the finite element calculations using a Norton creep law. The results obtained were compared with those obtained from corresponding creep damage analyses. For the cases investigated, it has been shown that, compared with damage results, conservative failure lives with consistent failure positions were obtained for the pipe weld, using both the LFR and the SFR methods. For plain pipes and pipe bends, the SFR prediction produces conservative results. However, the LFR prediction overestimates the failure life for the range of pipe diameter ratios investigated. The results obtained indicate that the LFR and SFR methods have potential for predicting creep failure lives in cases when the effect of geometry change is significant and hence the method based on the steady state peak stresses obtained from small deformation analysis is not applicable.Keywords
This publication has 13 references indexed in Scilit:
- Effect of geometry change on the creep failure life of a thick-walled CrMoV pipe with a circumferential weldmentInternational Journal of Pressure Vessels and Piping, 2004
- Creep Testing and Finite Element Modelling of TIG Butt-Welded Inco718 Sheets at 620°CMaterials Science Forum, 2003
- Life estimation of pressurised pipe bends using steady-state creep reference rupture stressesInternational Journal of Pressure Vessels and Piping, 2002
- Steady-state creep reference rupture stresses for internally pressurised pipes for use in life predictionInternational Journal of Pressure Vessels and Piping, 2002
- Creep crack growth in welds: a damage mechanics approach to predicting initiation and growth of circumferential cracksInternational Journal of Pressure Vessels and Piping, 2001
- Comparison of the creep and damage failure prediction of the new, service-aged and repaired thick-walled circumferential CrMoV pipe welds using material properties at 640°CInternational Journal of Pressure Vessels and Piping, 2000
- Prediction of creep failure life of internally pressurised thick walled CrMoV pipesInternational Journal of Pressure Vessels and Piping, 1999
- Creep Continuum Damage Constitutive Equations for the Base, Weld and Heat-Affected Zone Materials of a Service-Aged {1 over 2}cr{1 over 2}mo{1 over 4}v:2{1 over 4}cr1mo Multipass Weld at 640 °cThe Journal of Strain Analysis for Engineering Design, 1997
- Continuum damage mechanics modelling of high temperature deformation and failure in a pipe weldmentProceedings of the Royal Society of London. Series A: Mathematical and Physical Sciences, 1991
- The behaviour of ferritic weldments in thick section pipe at elevated temperatureInternational Journal of Pressure Vessels and Piping, 1985