Assessment of the Influence of Antisolvent 3D Printing Conditions on the Mechanical and Biological Properties of Poly(lactic-co-glycolic) Acid Scaffolds
Authors:
- Anton V. MironovAMAnton V. Mironov
- Ekaterina M. TrifanovaETEkaterina M. Trifanova
- Tatyana B. BukharovaTBTatyana B. Bukharova
- Andrey V. VasilyevAVAndrey V. Vasilyev
- Viktoria O. ChernomyrdinaVCViktoria O. Chernomyrdina
- Irina A. NedorubovaINIrina A. Nedorubova
- Valeriya S. KuznetsovaVKValeriya S. Kuznetsova
- Andrey G. DunaevADAndrey G. Dunaev
- Vladimir K. PopovVladimir K. Popov
- Anatoly A. KulakovAKAnatoly A. Kulakov
- Fedor F. LosevFLFedor F. Losev
- Dmitry V. GoldshteinDGDmitry V. Goldshtein
Open Access
Abstract
This paper describes an evaluation of the mechanical and biological properties of highly porous, biocompatible poly(lactic-co-glycolic acid) (PLGA) scaffolds produced using the antisolvent 3D printing technique under various forming conditions. The dependence of the scaffolds’ microstructure, PLGA molecular weight distribution, and cell adhesion properties on temperature and injection nozzle diameter was evaluated. All samples consisted of fibers with different inner polymer distributions formed by specific radial, highly porous structures with a mean pore length of less than 50 μm and a diameter below 10 μm. The microstructure formed using a nozzle with a diameter of 160 μm showed a moderate correlation with printing temperature, while for the 330 μm nozzle, there was no significant difference in microstructures formed at different temperatures. Scaffolds produced at lower temperatures of 4 °C with a thin nozzle showed better compression load characteristics in terms of strength. In contrast, a larger nozzle allowed the production of a PLGA structure with improved elasticity. A 10–17% change in the molecular weight of PLGA was observed during printing, but no influence on biological properties was found. All types of PLGA scaffolds tested demonstrated good biocompatibility and promoted cell adhesion compared to the control.Keywords
Funding Information
- Russian Science Foundation (22-15-00425)
This publication has 26 references indexed in Scilit:
- 3D printing of polylactic-co-glycolic acid fiber scaffolds using an antisolvent phase separation processPolymer, 2019
- Recent advances of PLGA micro/nanoparticles for the delivery of biomacromolecular therapeuticsMaterials Science and Engineering: C, 2018
- Mechanical properties of 3D printed polymeric cellular materials with triply periodic minimal surface architecturesMaterials & Design, 2017
- 3D printing of PLGA scaffolds for tissue engineeringJournal of Biomedical Materials Research Part A, 2016
- Current trends in the design of scaffolds for computer-aided tissue engineeringActa Biomaterialia, 2014
- Injectable poly(lactic-co-glycolic) acid scaffolds with in situ pore formation for tissue engineeringActa Biomaterialia, 2009
- Preparation of poly(lactic acid) hollow fiber membranes via phase separation methodsJournal of Membrane Science, 2009
- Induction of osteoblast differentiation phenotype on poly(l-lactic acid) nanofibrous matrixBiomaterials, 2008
- Structure formation in injectable poly(lactide-co-glycolide) depots. II. Nature of the gelJournal of Biomedical Materials Research, 2004
- Bioresorbability and biocompatibility of aliphatic polyestersJournal of Materials Science: Materials in Medicine, 1992