The Wear on Roller Press Rollers Made of 20Cr4/1.7027 Steel under Conditions of Copper Concentrate Briquetting
Open Access
- 17 December 2020
- Vol. 13 (24) , 5782
Abstract
This paper defines the wear process of rollers made of 20Cr4. Rollers with a diameter of 1000 mm were installed in a roller press used for the production of drop-shaped briquettes and the copper concentrate was briquetted for 1100 h. Three-dimensional (3D) geometry analysis, metallographic analysis, macroscopy, scanning electron microscopy, as well as hardness measurements were performed. It was observed that the working surface was non-uniformly worn. The smallest wear affects the molding cavities situated on the outermost edges of the ring. The wear increases as the center of the ring is approximated, and it reaches its maximum at the middle of the ring. The molding cavities also wear asymmetrically. For the shape considered in this study, the lower part of a cavity is subject to a higher wear rate. We found that the material of the working ring was carburized, but its hardness was significantly lower than required. The roller ring microstructure changes depended on the distance from the cavity’s face. An investigation of the wear mechanisms showed different types of abrasive wear, corrosive processes, and plastic deformation. The exact type and course of wear were described, depending on the location on the working surface.Keywords
Funding Information
- The article was funded by Subsidy grant number (16.16.130.942/KSW)
This publication has 26 references indexed in Scilit:
- Briquetting of EAF Dust for its Utilisation in Metallurgical ProcessesChemical and Process Engineering: New Frontiers, 2015
- Comparison of slip-rolling behaviour between 20MnCr5 gear steel, 36NiCrMoV1-5-7 hot working tool steel and 45SiCrMo6 spring steelWear, 2015
- Comparison of Mechanical Properties and Resistance to Creep of 20MnCr5 Steel and X10CrAlSi25 SteelProcedia Engineering, 2015
- Comparison of material properties: Steel 20MnCr5 and similar steelsJournal of Constructional Steel Research, 2014
- Pelletization process of postproduction plant wasteInternational Agrophysics, 2012
- Practical application of roller compaction process modelingComputers & Chemical Engineering, 2010
- Roll compaction of a pharmaceutical excipient: Experimental validation of rolling theory for granular solidsChemical Engineering Science, 2005
- Use of aqueous polymer quenchants for hardening of carbonitrided partsInternational Journal of Materials and Product Technology, 2005
- An interdisciplinary approach to size enlargement by agglomerationPowder Technology, 2003
- Cinematics and volume deformations during roll-press briquettingJournal of Materials Processing Technology, 2001