Super‐high fraction of organic montmorillonite filled polyamide 6 composite foam: Morphologies, thermal and mechanical properties
- 25 September 2020
- journal article
- research article
- Published by Wiley in Polymers for Advanced Technologies
- Vol. 32 (2) , 544-552
Abstract
High fraction of inorganic compounds filled polymer composites with lightweight character show a potential application on building and transportation. In this study, super‐high fraction of organic montmorillonite (OMMT>30%) filled Polyamide 6 (PA6) foams were prepared via a solution foaming. The influence of OMMT content on structures and properties of foams was studied. When the OMMT content was higher than 50%, the surface of cells turned from smooth to nest‐like appearance. The addition of excessive clay depressed the crystalline behavior of PA6 during foaming. However, it did not damage the compressive mechanical properties of foams. PA6 macromolecules played a role of binder, endowing interfacial strength and structural integrity of cell walls. With the increase of OMMT loading content from 33% to 75%, the composite foams showed an increased specific moduli from 2.8 to 4.1 MPa. The current work realized a facile processing of polymer foams with high loading of fillers. The corresponding filler dominant lightweight products open the door to a wide range of potential applications to reduce the use of non‐biodegradable plastics.Keywords
Funding Information
- Natural Science Foundation of Tianjin Municipality (18JCQNJC71600)
This publication has 35 references indexed in Scilit:
- Thermo-mechanical behaviour of Polyamide 6 chain extended with 1,1′-Carbonyl-Bis-Caprolactam and 1,3-Phenylene-Bis-2-OxazolineJournal of Polymer Research, 2013
- Effects of nanotalc inclusion on mechanical, microstructural, melt shear rheological, and crystallization behavior of polyamide 6‐based binary and ternary nanocompositesPolymer Engineering & Science, 2010
- Polypropylene foam behaviour under dynamic loadings: Strain rate, density and microstructure effectsInternational Journal of Impact Engineering, 2009
- An experimental study on the thermal conductivity of aluminium foams by using the transient plane source methodInternational Journal of Heat and Mass Transfer, 2008
- Enhancement in thermal and mechanical properties of polyurethane foam infused with nanoparticlesMaterials Science and Engineering: A, 2008
- Impact of diffusion on concentration profiles around near-critical nuclei and implications for theories of nucleation and growthActa Materialia, 2008
- Polymer nanocomposites based on needle‐like sepiolite clays: Effect of functionalized polymers on the dispersion of nanofiller, crystallinity, and mechanical propertiesJournal of Applied Polymer Science, 2007
- Polymer nanocomposite foamsComposites Science and Technology, 2005
- A flammability performance comparison between synthetic and natural clays in polystyrene nanocompositesFire and Materials, 2004
- Meso/Macroporous Inorganic Oxide Monoliths from Polymer FoamsAdvanced Materials, 2003