A study of coextrusion in a circular die
Author:
- 1 July 1975
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 19 (7) , 1875-1883
Abstract
An experimental study has been carried out of concentric and eccentric two‐phase flow of polymer melts in a circular die. For the study, a special die was constructed such that two separate streams of molten polymer could be supplied to the die inlet. Materials used for study were low‐density polyethylene, high‐density polyethylene, and polystyrene. In the experiment, two different capillary length‐to‐diameter (L/D) ratios were employed: 4 and 18. For a die having an L/D ratio of 18, wall normal stresses were measured, permitting the determination of the pressure gradient and hence the viscous property. For each set of extrusion conditions (L/D ratio, flow rate, component ratio), extrudate samples were collected. These were later carefully cross sectioned and photographed in order to examine the shape of the interface between the two components. It has been found that the lower‐viscosity components tends to wrap around the higher‐viscosity component, which is consistent with the previous observations reported in the literature.Keywords
This publication has 6 references indexed in Scilit:
- An Experimental Study of Rheological Properties of Polymer Melts in Laminar Shear Flow and of Interface Deformation and Its Mechanisms in Two-Phase Stratified FlowTransactions of the Society of Rheology, 1974
- On Silt- and Capillary-Die RheometryTransactions of the Society of Rheology, 1974
- Theory of Stratified Bicomponent Flow of Polymer Melts. I. Equilibrium Newtonian Tube FlowTransactions of the Society of Rheology, 1973
- A Theoretical Analysis of Bicomponent Flow and the Problem of Interface ShapeTransactions of the Society of Rheology, 1973
- Stratified two-phase flow of molten polymersJournal of Applied Polymer Science, 1973
- A study of bicomponent coextrusion of molten polymersJournal of Applied Polymer Science, 1973