Experimental study of the thermoforming of a blend of styrene‐butadiene copolymer with polystyrene
Authors:
- 1 February 1997
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 37 (2) , 450-459
Abstract
Material characterization and thermoforming studies were completed using a blend of a styrene‐butadiene copolymer with polystyrene used commercially for the production of cups and dishes. This composition was thermoformed between 135 and 152°C. Studies consisted of forming 30‐mil and 46‐mil sheets at 130, 140, and 150°C at three evacuation rates in an aluminum cylindrical mold. The mold was instrumented with a pressure transducer to follow the change in pressure during forming and two Linear Voltage Displacement Transducers, which served as mold wall contact sensors. The results indicated that the process is extremely rapid (0.25–0.60 sec) for the high and medium evacuation rates. The process was found to require a low pressure differential for forming (typically <4 psi). The final part thickness distribution and extension ratio data indicated that the material stretches into the approximate shape of a spherical segment, contacts the bottom/ center of the mold, contacts the sides, and finally stretches into the corners. The tensile strength and modulus of elasticity measurements of the final part were slightly less than the original sheet properties for samples measured in the machine direction but slightly greater for samples taken in the transverse direction. However, the percent elongation at break increased significantly in both the machine and transverse directions.Keywords
This publication has 5 references indexed in Scilit:
- Experimental study on the dynamics of thermoforming of polystyrenePolymer Engineering & Science, 1994
- Finite element analysis of inflation of an axisymmetric sheet of finite thicknessJournal of Rheology, 1991
- Three‐dimensional finite element simulation of thermoformingPolymer Engineering & Science, 1990
- Blow molding and thermoforming of plastics: Finite element modelingComputers & Structures, 1987
- THE USE OF KETAMINE HYDROCHLORIDE FOR ENDOTRACHEAL INTUBATION IN CATTLEAustralian Veterinary Journal, 1979