Effects of Intake Port Geometry on Large Scale In-Cylinder Flows
Authors:
- William ChurchWCWilliam Church
- P. V. FarrellPFP. V. Farrell
- 23 February 1998
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
A set of experiments has been performed which were aimed at quantifying the effects of specific intake port geometry changes on large-scale in-cylinder motions. Using a modular engine with replaceable intake port blocks, 3 different intake ports were used and results obtained at 3 crank angles: BDC, 90° before TDC of compression, and at TDC of compression. For each port, in-cylinder flows were quantified using a pulsed laser and high-speed imager. The resulting images were analyzed using a particle-tracking scheme. The results of the experiments indicate that there are significant differences among the flows produced by the ports, particularly at BDC. Nearer TDC, the differences among the flows diminish, but some differences in velocity and vorticity scale and distribution remain. Tumble ratios are shown, using a variety of tumble ratio calculation methods. In general, the methods give similar results showing moderate change in tumble from BDC to 90° BTDC, then a significant decrease to TDC.Keywords
This publication has 6 references indexed in Scilit:
- Correlation of the Combustion Characteristics of Spark Ignition Engines With the In-Cylinder Flow Field Characterised Using PIV in a Water Analogy RigSAE International Journal of Advances and Current Practices in Mobility, 1997
- Particle Image Velocimetry Measurements of Barrel Swirl in a Production Geometry Optical IC EngineSAE International Journal of Advances and Current Practices in Mobility, 1994
- Study of Induction Tumble by Particle Tracking Velocimetry in a 4-Valve EngineSAE International Journal of Advances and Current Practices in Mobility, 1991
- The Effects of Intake-Flow Configuration on the Heat-Release and Heat-Transfer Characteristics of a Single-Cylinder Four-Valve S.I. EngineSAE International Journal of Advances and Current Practices in Mobility, 1991
- Multidimensional Port-and-Cylinder Flow Calculations for Two- and Four-Valve-Per-Cylinder Engines: Influence of Intake Configuration on Flow StructureSAE International Journal of Advances and Current Practices in Mobility, 1990
- Instantaneous Planar Measurements of Velocity and Large-Scale Vorticity and Strain Rate in an Engine Using Particle-Image VelocimetrySAE International Journal of Advances and Current Practices in Mobility, 1989