Modified TiO2 Nanostructures Immobilized on Titanium Mesh for Selective Photocatalytic CO2 Reduction
Authors:
- Renat BeissenovRBRenat Beissenov
- Azamat KudaibergenAKAzamat Kudaibergen
- Bolat BazarbayevBBBolat Bazarbayev
- Raigul JumanovaRJRaigul Jumanova
- Yerkezhan BeisenovaYBYerkezhan Beisenova
- Wenduo YangWYWenduo Yang
- Baodan LiuBLBaodan Liu
Preprint
- 27 July 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
Immobilized TiO2-based photocatalysts are promising for CO2 photoreduction because they combine chemical stability, mechanical robustness, and potential compatibility with continuous-flow systems. In this work, TiO2 nanostructures were synthesized directly on titanium mesh by alkaline hydrothermal treatment. The effects of NaOH concentration, Pt photodeposition, and nitrogen doping on morphology, structure, optical properties, and CO2 photoreduction performance were investigated. SEM analysis showed that dense nanosheet TiO2 layers were formed on the Ti mesh surface. Increasing the NaOH concentration from 2 to 3M enhanced nanostructure growth and increased the oxide layer thickness from approximately 4.3 to 6.1 μm, although local structural damage appeared at higher alkalinity. XRD confirmed the formation of crystalline anatase TiO2, while EDS verified Pt deposition and nitrogen incorporation. UV-Vis analysis showed strong UV absorption and slight narrowing of the apparent optical band gap for modified photocatalysts. Photocatalytic CO2 reduction under UV irradiation produced CH4 and CO as main products. Pt/TiO2/Ti exhibited the best performance, achieving a CH4 formation rate of 40.59 μmol·g-1·h-1 and 99.5% electron selectivity after 11 h. Nitrogen doping enhanced total carbon-product formation but favored CO generation. These results demonstrate that Pt-functionalized TiO2/Ti mesh is an efficient immobilized photocatalyst for selective CO2-to-CH4 photoreduction.Keywords
This publication has 37 references indexed in Scilit:
- Microfluidic photocatalysis with defect-engineered TiO2Chemical Engineering Journal Advances, 2026
- Optimizing low-temperature defect engineering in TiO2 nanosheets for enhanced photocatalytic water splittingApplied Surface Science, 2025
- Understanding the effect of co-doped N,Pd/TiO2 dopants on the efficiency and product selectivity of the photocatalytic CO2 reductionApplied Surface Science, 2024
- Unravelling the effect of Ti3+/Ti4+ active sites dynamic on reaction pathways in direct gas-solid-phase CO2 photoreductionApplied Catalysis B: Environment and Energy, 2024
- A highly efficient supported TiO2 photocatalyst for wastewater remediation in continuous flowApplied Materials Today, 2023
- Nitrogen-stabilized oxygen vacancies in TiO2 for site-selective loading of Pt and CoOx cocatalysts toward enhanced photoreduction of CO2 to CH4Chemical Engineering Journal, 2022
- The Importance of the Macroscopic Geometry in Gas‐Phase PhotocatalysisAdvanced Science, 2022
- Visible Light-Responsive N-Doped TiO2 Photocatalysis: Synthesis, Characterizations, and ApplicationsTransactions of Tianjin University, 2021
- On the selectivity of CO2 photoreduction towards CH4 using Pt/TiO2 catalysts supported on mesoporous silicaApplied Catalysis B: Environment and Energy, 2018
- Photocatalytic Reduction of CO2 on TiO2 and Other SemiconductorsAngewandte Chemie International Edition, 2013