Cavitation erosion behaviour and mechanism of HVOF-sprayed NiCrBSi–(Cr3C2–NiCr) composite coatings
Authors:
- 1 March 2018
- journal article
- research article
- Published by SAGE Publications in Surface Engineering
- Vol. 34 (3) , 211-219
Abstract
NiCrBSi–(Cr3C2–NiCr) coatings were prepared by high velocity oxy-fuel (HVOF) thermal spraying technique, and their cavitation erosion behaviour was investigated by a magnetostrictive cavitation method. It was observed that in the initial 8 h, cavitation occurred at higher rate, and cumulative mass loss of the two coatings was apparently higher than that of the substrate. Conversely, beyond 12 h, the former was lower than the later, indicating that the coatings depressed the cavitation erosion effectively. This study verified that the cavitation is due to mechanical shock, turbulence of liquid with bubbles and residual stresses, and therefore the formation of cracks and the delamination of coating are induced. Furthermore, an increase in the number of pores results in an increase in damage to the coatings, taking this into account distributions of pores can be termed as a key factor in determining the resistance of cavitation damage.Keywords
Funding Information
- Natural Science Foundation of Jiangsu Province (BK20161506)
- National Natural Science Foundation of China (51301059)
- State Key Laboratory of High Performance Ceramics and Superfine Microstructure (SKL201401SIC)
- Fundamental Research Funds for Central Universities (2015B01914)
- National 973 Plan Project (2015CB057803)
- Natural Science Foundation of Jiangsu Province (BK20161506)
- National Natural Science Foundation of China (CN) (51301059)
- State Key Laboratory of High Performance Ceramics and Superfine Microstructure (SKL201401SIC)
- Fundamental Research Funds for Central Universities (2015B01914)
- National 973 Plan Project (2015CB057803)
This publication has 24 references indexed in Scilit:
- Cr3C2–NiCr and WC–Ni thermal spray coatings as alternatives to hard chromium for erosion–corrosion resistanceSurface and Coatings Technology, 2008
- A comparative study of hot corrosion resistance of HVOF sprayed NiCrBSi and Stellite-6 coated Ni-based superalloy at 900°CMaterials Science and Engineering: A, 2007
- Development and trends in HVOF spraying technologySurface and Coatings Technology, 2006
- Comparative study of Cr3C2–NiCr coatings obtained by HVOF and hard chromium coatingsCorrosion Science, 2006
- Cavitation Erosion Resistance of WC-Cr-Co and Cr3C2-NiCr Coatings Prepared by HVOFAdvanced Materials Research, 2006
- Corrosion mechanism of NiCrBSi coatings deposited by HVOFSurface and Coatings Technology, 2005
- Electrochemical evaluation of corrosion resistance of NiCrBSi coatings deposited by HVOFSurface and Coatings Technology, 2004
- The influence of gun transverse speed on electrochemical behaviour of thermally sprayed Cr3C2–NiCr coatings in 0.5 M H2SO4 solutionElectrochimica Acta, 2004
- Development of dense corrosion resistant coatings by an improved HVOF spraying processScience and Technology of Advanced Materials, 2003
- Abrasive Wear Performance of Cr3C2-25%NiCr Coatings by Plasma Spray and CDS Detonation SprayTribology Transactions, 1995