A study of heat treatment of high‐boron high‐speed steel roll
Authors:
- 16 July 2013
- journal article
- research article
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 44 (7) , 612-617
Abstract
High‐boron high‐speed steel (HSS) is a cheap roll material. In the paper, the authors research the effect of heat treatment on the microstructure and properties of high‐boron high‐speed steel HSS roll containing 0.54% C, 1.96% B, 3.82% W, 7.06% Mo, 5.23% Cr and 2.62% Al by means of the optical microscopy (OM), the scanning electron microscopy (SEM), X‐ray diffraction (XRD) and hardness test. The results showed that as‐cast structure of boron‐bearing high‐speed steel HSS consisted of martensite, pearlite, M2(B, C), M3(B, C) and M23(B, C)6 type borocarbides. After quenching, the matrix transformed into the lath martensite, and M3(B, C) dissolved into the matrix. When quenching temperature is lower than 1050°C, the hardness is increased with the increase of quenching temperature under oil cooling, while quenching temperature excels 1100°C, the hardness will decrease with the increase of quenching temperature. Under the condition of salt bath and air cooling, the effect of quenching temperature on the hardness is similar to the above law, but the quenching temperature obtaining the highest hardness is higher than that of oil cooling. The highest hardness is obtained while tempering at 525°C. The hardness of high‐boron high‐speed steel HSS roll is 66.5 HRC, and its impact toughness excels 13.1 J/cm2. Using in pre‐finishing stands of high‐speed hot wire‐rod rolling mill, the wear rate of high‐boron HSS rolls is 0.26 mm/one thousand tons steel. However the manufacturing cost of high‐boron HSS rolls is obviously lower than that of powder metallurgy hard alloy rolls, it is only 28% of that of powder metallurgy (PM) hard alloy rolls.Keywords
This publication has 12 references indexed in Scilit:
- Effect of boron concentration on the solidification microstructure and properties of Fe‐Cr‐B alloyMaterialwissenschaft und Werkstofftechnik, 2011
- Heat treatment of centrifugally cast high carbon high vanadium high speed steel mill rollIronmaking & Steelmaking: Processes, Products and Applications, 2011
- Effect of electromagnetic centrifugal casting on solidification microstructure of cast high speed steel rollMaterialwissenschaft und Werkstofftechnik, 2011
- Research on Microstructure and Mechanical Properties of High Boron Cast SteelAdvanced Materials Research, 2011
- Effects of Alloying Elements on Microstructure, Hardness, Wear Resistance, and Surface Roughness of Centrifugally Cast High-Speed Steel RollsMetallurgical and Materials Transactions A, 2009
- Investigations on microstructures and properties of B containing cast steel for wear resistance applicationsIronmaking & Steelmaking: Processes, Products and Applications, 2008
- Boron solubility in Fe–Cr–B cast ironsMaterials Science and Engineering: A, 2003
- Hot rolling mill roll microstructure interpretation: A computational thermodynamics studyJournal of Phase Equilibria and Diffusion, 2001
- Microstructural Features of Prematurely Failed Hot-Strip Mill Work Rolls: Some Studies in Spalling PropensityJournal of Materials Engineering and Performance, 2000
- The effect of heat treatment on the abrasion resistance of alloy white ironsWear, 1997