Numerical approaches of high‐speed machining process are necessary to increase productivity and to optimisize tool wear and worked piece residual stresses. In this purpose, rheological behaviour and friction model have to be correctly determined. Actual numerical approaches with current friction models don’t lead to good correlations of process variables like cutting forces or chip‐tool contact length. This paper proposes a new approach to characterize the friction behaviour at the chip‐tool interface. First, a mechanical analysis enables to determine contact pressure, plastic strain, velocity and temperatures in this chip‐tool interface. This study concerns the interface zone near the cutting edge. A low sliding velocity combined with a contact pressure higher than 1 GPa is characteristic of this zone. An experimental device has been designed to simulate the friction behaviour at chip‐tool interface. During this upsetting‐sliding test, the indenter contacts the specimen and rubs against it with a constant velocity and generates a residual friction track. The forces, in both normal and tangential directions are measured in order to calculate the contact pressure σn and the friction stress σt. These variables are then used for identification of the friction data depending on the interface temperature and sliding velocity. Finally, perspectives are given for implementation of data in FEA machining models.