Temperature and strain monitoring during thermoforming of thermoplastic composite laminates using optical frequency domain reflectometry
Authors:
- 13 February 2024
- journal article
- research article
- Published by IOP Publishing in Smart Materials and Structures
- Vol. 33 (3) , 035021
Abstract
In this study, optical frequency domain reflectometry (OFDR) was used to monitor the thermoforming processes of carbon fiber reinforced thermoplastics (CFRTPs) to address the limitations of conventional sensors including large size and low spatial resolution. A bare single-mode fiber with a polyimide coating and a fiber encapsulated by a long metal capillary were cascaded and embedded into composite laminates to withstand the high pressure and temperature during thermoforming, and then connected to the OFDR for monitoring. A fiber encapsulated by a 2 cm short metal capillary was also embedded to demonstrate that a 1 mm resolution of the OFDR is beneficial for reflecting the local change in the composite. After processing by wavelet denoising, signal extraction, and decoupling, the frequency shift along the optical fiber sensor was successfully converted to strain and temperature. In two repeated thermoforming experiments that involved cooling from 340 °C, the average temperature difference measured by the OFDR and reference thermocouple was only 4.64 °C. The strain measured by the OFDR and reference fiber Bragg grating (FBG) decreases in the cooling stage, and has a clear knee point of 250 °C when correlated with the temperature and strain. This knee point is consistent with the liquid–liquid transition temperature of the polyetherimide and indicates the beginning of consolidation when the composite changes its properties significantly. The average strain difference measured by OFDR and the reference FBG was 69 μϵ when the total strain is approximately 1820 μϵ if only considering the consolidation process from 250 °C. The results of 1 mm spatial resolution and high accuracy demonstrate that OFDR is a promising high-resolution sensing solution for the in-situ temperature and strain monitoring of the thermoforming of CFRTPs.Keywords
Funding Information
- National Key R&D Program of China (2021YFF0501800.)
- National Natural Science Foundation of China (11972016)
- Research Fund of State Key Laboratory of Mechanics and Control for Aerospace Structures (MCMS-I-0521G04)
This publication has 33 references indexed in Scilit:
- Process monitoring of glass reinforced polypropylene laminates using fiber Bragg gratingsComposites Science and Technology, 2016
- Distributed internal strain measurement during composite manufacturing using optical fibre sensorsComposites Science and Technology, 2015
- Reactive mold filling in resin transfer molding processes with edge effectsJournal of Applied Polymer Science, 2009
- Fibre Bragg gratings in structural health monitoring—Present status and applicationsSensors and Actuators A: Physical, 2008
- Experimental investigation of the effect of the mould thermal expansion on the development of internal stresses during carbon fibre composite processingComposites Part A: Applied Science and Manufacturing, 2008
- Enhancements of the simulation method on the edge effect in resin transfer molding processesMaterials Science and Engineering: A, 2008
- Residual stresses in thermoplastic composites—A study of the literature—Part I: Formation of residual stressesComposites Part A: Applied Science and Manufacturing, 2006
- Residual strain development in an AS4/PPS thermoplastic composite measured using fibre Bragg grating sensorsComposites Part A: Applied Science and Manufacturing, 2006
- A method of stress analysis for interfacial property evaluation in thermoplastic compositesMaterials Science and Engineering: A, 2000
- High-spatial-resolution distributed strain measurement in optical fiber with Rayleigh scatterApplied Optics, 1998