Low‐Voltage Polyelectrolyte‐Gated Polymer Field‐Effect Transistors Gravure Printed at High Speed on Flexible Plastic Substrates
Open Access
- 27 December 2016
- journal article
- research article
- Published by Wiley in Advanced Electronic Materials
- Vol. 3 (2)
Abstract
This study reports the fabrication of polymer field‐effect transistors operating under a bias of |1 V| in which the insulator and semiconductor are gravure‐printed on plastic at the high speed of 0.7 m s−1. Remarkably, the process does not necessitate any surface modification and relies solely on the careful selection and optimization of formulations based on solvent blends. In addition to demonstrating high‐throughput fabrication, this study fulfills another requirement for organic electronics and achieves low‐voltage operation in ambient air by using a polyelectrolyte insulator, poly(4‐styrenesulfonic acid) (PSSH). PSSH is a proton conductor that forms electrical double layers at the interfaces with the gate electrode and the semiconductor channel upon application of a small gate voltage (≤ |1 V|). Printed PSSH exhibits a high capacitance of 10 µF cm−2, leading to a printed poly(3‐hexylthiophene) hole mobility above 0.1 cm2 V−1 s−1 in a bottom‐gate, top‐contact configuration.Keywords
Funding Information
- Seventh Framework Programme (607896)
This publication has 36 references indexed in Scilit:
- New opportunities for organic electronics and bioelectronics: ions in actionChemical Science, 2012
- Determination of the P3HT:PCBM solubility parameters via a binary solvent gradient method: Impact of solubility on the photovoltaic performanceSolar Energy Materials and Solar Cells, 2012
- High performance, flexible polymer light-emitting diodes (PLEDs) with gravure contact printed hole injection and light emitting layersOrganic Electronics, 2010
- Printed Sub‐2 V Gel‐Electrolyte‐Gated Polymer Transistors and CircuitsAdvanced Functional Materials, 2010
- Comparison of the Mobility–Carrier Density Relation in Polymer and Single‐Crystal Organic Transistors Employing Vacuum and Liquid Gate DielectricsAdvanced Materials, 2009
- Absence of substrate roughness effects on an all-printed organic transistor operating at one voltApplied Physics Letters, 2008
- Ring oscillator fabricated completely by means of mass-printing technologiesOrganic Electronics, 2007
- High Carrier Density and Metallic Conductivity in Poly(3‐hexylthiophene) Achieved by Electrostatic Charge InjectionAdvanced Functional Materials, 2006
- Gate Dielectrics for Organic Field‐Effect Transistors: New Opportunities for Organic ElectronicsAdvanced Materials, 2005
- High‐Performance All‐Polymer Transistor Utilizing a Hygroscopic InsulatorAdvanced Materials, 2004