Preparation and adhesive properties of colored Ti/Zr‐based conversion coating on aluminum foil for lithium battery packaging
Authors:
- 18 October 2018
- journal article
- research article
- Published by Wiley in Surface and Interface Analysis
- Vol. 51 (2) , 190-198
Abstract
In this study, an aluminum (Al) foil used for lithium ion battery packaging film was treated with titanium (Ti)/zirconium (Zr) solution containing hexafluorotitanic acid and hexafluorozirconic acid using tannic acid as a colorant and metavanadate as an accelerator, respectively, and a golden conversion coating was successfully deposited on the surface of Al foil. The morphology and composition of the coating were characterized by scanning electron microscopy, energy dispersive spectroscopy, and X‐ray photoelectron spectroscopy, and the hydrophilicity was assessed by contact angle measurement. The effect of Ti/Zr treatment on the adhesion properties of Al foil was evaluated by T‐peeling test and compared with that of traditional chromate‐phosphate treatment. The results show that tannic acid contributes to the formation of the golden coating, and metavanadate accelerates the formation of the conversion coating. The results also indicate that the Ti/Zr‐based conversion coating is mainly composed of Al 2 O 3 , Al (OH) 3 , AlF 3 , TiO 2 /ZrO 2 , NH 4 VO 3 , and V 2 O 5 . The Ti/Zr treatment cannot only improve the heat‐sealing strength, but also the T‐peeling strength by approximately 12 times compared with that of untreated Al foil. Thus, Ti/Zr treatment has the potential to replace the traditional chromate conversion treatment.Keywords
Funding Information
- Foundation of Qinghai Science and Technology Department (2017-HZ-803)
- Thousand Talents Program of Qinghai Province
- Kunlun Scholar Award Program of Qinghai Province
This publication has 44 references indexed in Scilit:
- Recycling of Spent Lithium-Ion Battery: A Critical ReviewCritical Reviews in Environmental Science and Technology, 2014
- Characterization of aluminum alloys environmentally friendly surface treatments for aircraft and aerospace industrySurface and Interface Analysis, 2013
- Preparation and Properties of Chrome-Free Colored Na3AlF6 Conversion Coating on Aluminum AlloyAdvanced Materials Research, 2012
- Lithium‐Ion Conducting Electrolyte Salts for Lithium BatteriesChemistry – A European Journal, 2011
- Influence of shot peening and hard chromium electroplating on the fatigue strength of 7050-T7451 aluminum alloyInternational Journal of Fatigue, 2007
- Detection of aluminium residue in sauces packaged in aluminium pouchesFood Chemistry, 2003
- Alteration of Ti 2p XPS spectrum for titanium oxide by low‐energy Ar ion bombardmentSurface and Interface Analysis, 2002
- Surface treatment of titanium for adhesive bonding to polymer composites: a reviewInternational Journal of Adhesion and Adhesives, 2001
- Development of a high-power lithium-ion batteryJournal of Power Sources, 1999
- Corrosion behaviour of fluotitanate pretreated and painted aluminium sheetsElectrochimica Acta, 1997