Plastic Load of Precracked Polyethylene Miter Pipe Bends Subjected to In-Plane Bending Moment1
- 7 October 2013
- journal article
- research article
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 135 (6)
Abstract
The main purpose of the present paper is to investigate the effect of crack depth on the plastic load (collapse load) of miter pipe bends (MPB) under in-plane bending moment. The experimental work is conducted to investigate multimiter pipe bends, with a bend angle 90 deg, pipe bend factor h = 0.844, standard dimension ratio (SDR) = 11, and number of welding junctions m = 3 under a crosshead speed 500 mm/min. The material of the investigated pipe is a high-density polyethylene (HDPE), which is used in natural gas (NG) piping systems. The welds in the miter pipe bends are produced by butt-fusion method. The crack depth varies from intrados to extrados location according to the in-plane opening/closing bending moment, respectively. For each in-plane bending moment, the plastic load is obtained by the tangent intersection (TI) method from the load–deflection curves produced by the testing machine specially designed and constructed in the laboratory.5 The study reveals that increasing the crack depth leads to a decrease in the stiffness and plastic load of MPB for both in-plane closing and opening bending moment. Higher values of the plastic load are reached in case of opening bending moment. This behavior is true for all investigated crack depths. A circumferential external crack has an obvious effect on the behavior of load–deflection curve. The linear elastic region in both mode of loading decreases with increasing crack depth.Keywords
This publication has 26 references indexed in Scilit:
- Finite element plastic loads for circumferential cracked pipe bends under in-plane bendingEngineering Fracture Mechanics, 2007
- Closed-form plastic collapse loads of pipe bends under combined pressure and in-plane bendingEngineering Fracture Mechanics, 2006
- An assessment of ASME III and CEN TC54 methods of determining plastic and limit loads for pressure system componentsThe Journal of Strain Analysis for Engineering Design, 2001
- Limit Loads for Pipe Elbows Subjected to In-Plane Opening Moments and Internal PressureJournal of Pressure Vessel Technology, 1999
- Limit Loads for Pipe Elbows With Internal Pressure Under In-Plane Closing Bending MomentsJournal of Pressure Vessel Technology, 1998
- Stress Analysis of Mitred Bends by Ring ElementsJournal of Pressure Vessel Technology, 1984
- The effect of cracks on the limit load of pipe bends under in-plane bendingInternational Journal of Mechanical Sciences, 1979
- Flexibility and stress factors for mitred bends under in-plane bendingInternational Journal of Mechanical Sciences, 1970
- Elastic-plastic behaviour of pipe bends with in-plane bendingJournal of Strain Analysis, 1967
- Elastic Solution in the Limit Analysis of Shells of Revolution with Special Reference to Expansion BellowsJournal of Mechanical Engineering Science, 1961