Selective Laser Sintering versus Selective Laser Melting and Computer Aided Design – Computer Aided Manufacturing in Double Crowns Retention
Open Access
- 1 January 2021
- journal article
- research article
- Published by Japan Prosthodontic Society in Journal of Prosthodontic Research
- Vol. 65 (3) , 371-378
Abstract
Purpose: This in vitro study aimed at ascertaining the retention forces for telescopic crowns fabricated with Selective Laser Manufacturing (SLM) and Selective Laser Sintering (SLS) additive technologies, and Computer Aided Design – Computer Aided Manufacturing (CAD–CAM) subtractive technology, by using suitable materials for each. Materials and Methods: Full-factorial design was employed for experimental testing, considering the following three factors: (a) inner crown material ‒ technology (zirconia ‒ CAD-CAM; metal-alloy ‒ SLS; metal-alloy ‒ SLM); (b) tooth type (canine or molar); (c) wet vs. dry conditions (i.e. either with or without artificial saliva). The roughness of the inner crowns was analyzed through atomic force microscopy. Three-way analysis of variance (ANOVA) was applied for statistical analysis, followed by Tukey's post-hoc comparisons between the crown types. Results: The retention force mean values were between 3.8 N (dry, SLM) and 14.8 N (artificial saliva, SLS), with statistically significant (p<0.001) differences between the three types of inner crowns and interaction with the tooth type. No significant interaction was found between crown or tooth types and the wet vs. dry testing conditions. The zirconia crowns' retention force was significantly (p<0.001) higher compared to similar SLM crowns, with 95% CI (3.62; 5.55) N for the differences. Zirconia was sig nificantly (p<0.001) less retentive compared to similar SLS crow ns, with 95% CI (-5.99; -4.06) N for the differences. The roughness decrease and subsequent loss of retention force was the largest in zirconia. Conclusions: The SLS inner crowns showed the best retention, followed by zirconia and SLM inner crows.Keywords
This publication has 37 references indexed in Scilit:
- Retention forces of 14-unit zirconia telescopic prostheses with six double crowns made from zirconia—an in vitro studyClinical Oral Investigations, 2013
- Evaluation of the marginal and internal gap of metal-ceramic crown fabricated with a selective laser sintering technology: two- and three-dimensional replica techniquesThe Journal of Advanced Prosthodontics, 2013
- Wear behavior of different double-crown systemsClinical Oral Investigations, 2012
- Clinical retention force development of double crownsClinical Oral Investigations, 2011
- Zirconia Removable Telescopic Dentures Retained on Teeth or Implants for Maxilla Rehabilitation. Three-Year Observation of Three CasesJournal of Oral Implantology, 2010
- Retention of telescopic denture in elderly patients with maximum partially edentulous archGerodontology, 2008
- Telescopic Crowns as Attachments for Implant Supported Restorations: A Case SeriesJournal of Oral Implantology, 2006
- Parameters affecting retentive force of conus crownsJournal of Oral Rehabilitation, 2004
- Retention force changes in implant‐supported titanium telescope crowns over long‐term use in vitroJournal of Oral Rehabilitation, 1996
- Prosthetic rehabilitation with the removable partial dentures using telescopic crowns after removal of unsuccessful dental implants.Nihon Hotetsu Shika Gakkai Zasshi, 1989