Mechanical Properties of Transparent Polycrystalline Silicon Nitride
- 15 August 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 317-318, 305-308
Abstract
A novel transparent polycrystalline silicon nitride was fabricated by hot-press sintering with MgO and AlN as additives. The mixed powder with 3 wt.% MgO and 9 wt.% AlN was sintered at 1900oC for 1 hour under 30 MPa pressure in a nitrogen gas atmosphere. Transparent polycrystalline silicon nitride was successfully fabricated. The mechanical properties such as density, hardness, young’s modulus, fracture strength and fracture toughness were evaluated. The effect of α/β phase on the mechanical properties of transparent polycrystalline silicon nitride was investigated. The properties were changed depending on the amount of α/β phase. The hardness and Young's modulus increased with increasing the volume fraction of α-phase fraction as a reflection of the higher hardness of α-phase Si3N4. The fracture toughness and fracture strength decreased with decreasing the volume fraction of β-phase Si3N4.Keywords
This publication has 7 references indexed in Scilit:
- Transparent Alumina: A Light‐Scattering ModelJournal of the American Ceramic Society, 2003
- Effect of α/β phase ratio on microstructure and mechanical properties of silicon nitride ceramicsJournal of Materials Research, 2001
- Low‐Temperature Fabrication of Transparent Yttrium Aluminum Garnet (YAG) Ceramics without AdditivesJournal of the American Ceramic Society, 2000
- Aluminum magnesium oxynitride: A new transparent spinel ceramicJournal of the European Ceramic Society, 1995
- Hardness of dense ?- and ?-Si3N4 ceramicsJournal of Materials Science Letters, 1985
- Phase Relations and Reaction Sintering of Transparent Cubic Aluminum Oxynitride Spinel (ALON)Journal of the American Ceramic Society, 1979
- Translucent Sintered MgAl 2 O 4Journal of the American Ceramic Society, 1974