New correlations for wavy plate-fin heat exchangers: different working fluids
Authors:
- Morteza Khoshvaght AliabadiMAMorteza Khoshvaght Aliabadi
- Faramarz HormoziFHFaramarz Hormozi
- Elham Hosseini RadERElham Hosseini Rad
- 27 May 2014
- journal article
- Published by Emerald Publishing in International Journal of Numerical Methods for Heat & Fluid Flow
- Vol. 24 (5) , 1086-1108
Abstract
Purpose: – The main purpose of this paper is the generation of the heat transfer and pressure drop correlations by considering three working fluids, namely air, water, and ethylene glycol, for the wavy plate-fin heat exchangers (PFHEs).Design/methodology/approach: – In order to present the general correlations, various models with different geometrical parameters should be tested. Because of the problems, such as difficult, long time, and costly fabrication of the wavy fins in experimental tests, computational fluid dynamics (CFD) calculations can be a useful method for the generation of the heat transfer and pressure drop correlations with eliminating the experimental problems. Hence, the effective design parameters of the wavy plate-fin, including fin pitch, fin height, wave length, fin thickness, wave amplitude, and fin length, and also their levels were recognized from the literature. The Taguchi method was applied to formulate the CFD simulation work.Findings: – The simulation results were compared and validated with an available experimental data. The mean deviations of the Colburn factor,j, and Fanning friction factor,f, values between the simulation results and the experimental data were 3.74 and 9.07 percent, respectively. The presented air correlations and experimental data were in a good agreement, so that approximately 95 percent of the experimental data were correlated within ±12 percent. The j factor values varied for the different working fluids, while the f factor values did not sensibly change.Practical implications: – The presented correlations can be used to estimate the thermal-hydraulic characteristics and to design of the compact PFHE with the wavy channels.Originality/value: – This manuscript presents the new correlations for the compact PFHEs with the way channels by considering all the geometrical parameters and the working fluids with the different Prandtl numbers, 0.7, 7, and 150.Keywords
This publication has 39 references indexed in Scilit:
- 3D-CFD simulation and neural network model for the j and f factors of the wavy fin-and-flat tube heat exchangersBrazilian Journal of Chemical Engineering, 2011
- Correlations and optimization of a heat exchanger with offset-strip finsInternational Journal of Heat and Mass Transfer, 2011
- MODELS FOR PRESSURE DROP AND HEAT TRANSFER IN AIR COOLED COMPACT WAVY FIN HEAT EXCHANGERSJournal of Enhanced Heat Transfer, 2011
- Numerical Design of an Efficient Wavy Fin Surface Based on the Local Heat Transfer Coefficient StudyJournal of Enhanced Heat Transfer, 2007
- Effect of fin waviness and spacing on the lateral vortex structure and laminar heat transfer in wavy-plate-fin coresInternational Journal of Heat and Mass Transfer, 2004
- Heat transfer and pressure drop characteristics in a corrugated duct with rounded cornersInternational Journal of Heat and Mass Transfer, 1988
- Turbulent Heat Transfer in Corrugated-Wall Channels With and Without FinsJournal of Heat Transfer, 1987
- Effect of rounding of protruding edges on heat transfer and pressure drop in a ductInternational Journal of Heat and Mass Transfer, 1984
- Effect of interwall spacing and fluid flow inlet conditions on a corrugated-wall heat exchangerInternational Journal of Heat and Mass Transfer, 1983
- Corrugated-Duct Heat Transfer, Pressure Drop, and Flow VisualizationJournal of Heat Transfer, 1982