Mechanisms of Shock Strength Exhibited by a Nickel‐Rich Nickel‐Titanium‐Hafnium Alloy
- 12 October 2023
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 25 (22)
Abstract
Nickel‐rich NiTiHf alloys that are heat treated to strengthen the microstructures with a dense distribution of Ni4Ti3 nanoprecipitates exhibit very high strengths and good quasi‐static indentation resistance and rolling contact fatigue performances. To determine whether these properties are maintained at high rates of loading, in situ and recovery flyer plate impact shock experiments are performed on a Ni54Ti45Hf1 alloy at impact velocities ranging from approximately 150 m s−1 (2.5 GPa) to 700 m s−1 (12.40 GPa). Analysis of shocked samples indicated less cracking is observed to emanate from spall failures resulting from impact velocities greater than 250 m s−1 (4.23 GPa), concurrent with observations of intragranular microbands within the microstructures. Analyses show clear evidence that, like responses to quasi‐static loading, martensitic phase transformation occurs upon shock compression in all cases. However, dissimilarly, for the higher impact velocities it reverses upon stress release, leaving behind microbands that show no evidence for retained martensite and within which the Ni4Ti3 nanoprecipitates dissolved. These results indicate that strain‐rate dependence of these SMAs under shock loading is not only governed by the expected physics of rate‐dependence of the martensitic transformations themselves but may also be enhanced by inelastic deformation mechanisms that result in precipitate dissolution.Keywords
Funding Information
- Glenn Research Center (#80NSSC21M0099, 19-TTT-0065)
This publication has 21 references indexed in Scilit:
- In Situ Neutron Diffraction Studies of Increasing Tension Strains of Superelastic NitinolShape Memory and Superelasticity, 2015
- Behavior of the nickel-titanium alloys with the shape memory effect under conditions of shock wave loadingPhysics of the Solid State, 2011
- Strong stabilization of the Rayleigh–Taylor instability by material strength at megabar pressuresPhysics of Plasmas, 2010
- Damping, tensile, and impact properties of superelastic shape memory alloy (SMA) fiber-reinforced polymer compositesComposites Part B: Engineering, 2010
- Rare twin linked to high-pressure phase transition in ironScripta Materialia, 2009
- Behavior of the shape memory alloy NiTi during one-dimensional shock loadingJournal of Applied Physics, 2002
- Compressive superelastic behavior of a NiTi shape memory alloy at strain rates of 0.001–750 s−1International Journal of Solids and Structures, 2001
- Thermomechanical characterization of NiTiCu and NiTi SMA actuators: influence of plastic strainsSmart Materials and Structures, 2000
- Shock-induced martensitic transformations in near-equiatomic NiTi alloysMetallurgical and Materials Transactions A, 1997
- On the kinetics of an austenite → martensite phase transformation induced by impact in a CuAlNi shape-memory alloyActa Materialia, 1997