Processability of high-strength aluminum 6182 series alloy via laser powder bed fusion (LPBF)
Authors:
Open Access
- 14 January 2022
- journal article
- research article
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- Vol. 119 (7-8) , 4963-4977
Abstract
The growing demand for more materials available for the LPBF-process, in particular high-strength aluminum alloys, is evident in the market. In the present work, a systematic investigation of the processability of aluminum 6182 series alloys, using LPBF, was carried out. For this purpose, the influence of process parameters, especially of enhanced preheating by heating the substrate plate during the LPBF process, on the microstructure of EN AW 6182 specimens was studied.Experiments were conducted at different preheating temperatures always using the same d-optimal design-of-experiments, the laser power, scanning speed, hatch distance, and laser focus position being varied over a wide range.It was found that the preheating temperature has the strongest impact on hot cracking. Higher temperatures result in a significantly reduced number of hot cracks in the microstructure. Moreover, an equiaxed microstructure of the specimens manufactured can be observed at preheating temperatures of 500 °C. In addition to the preheating temperature, the achievable part density is most strongly affected by the laser focus position and the laser power, whereas the hatch distance shows no discernible impact on the part density. Furthermore, neither the hatch distance nor the laser focus position shows any significant effect on hot cracking.In combination with the optimal scanning parameters, crack-free parts with a fully equiaxed grain structure and densities > 99.0% can be manufactured via LPBF at a preheating temperature of 500 °C.Keywords
Funding Information
- University of Innsbruck and Medical University of Innsbruck
This publication has 48 references indexed in Scilit:
- Numerical investigation and an effective modelling on the Selective Laser Melting (SLM) process with aluminium alloy 6061International Journal of Heat and Mass Transfer, 2015
- Reducing porosity in AlSi10Mg parts processed by selective laser meltingAdditive Manufacturing, 2014
- Microstructure and mechanical properties of Al–12Si produced by selective laser melting: Effect of heat treatmentMaterials Science and Engineering: A, 2014
- Selective Laser MeltingPhotonicsViews, 2012
- High Power Selective Laser Melting (HP SLM) of Aluminum PartsPhysics Procedia, 2011
- 3D reconstruction of histological sections: Application to mammary gland tissueMicroscopy Research and Technique, 2010
- Aluminum alloys for lightweight automotive structures2010
- D-optimal designsChemometrics and Intelligent Laboratory Systems, 1995
- W. Kurz, D. J. Fisher, Fundamentals of Solidification. Trans Tech Publications, Switzerland‐Germany‐UK‐USA, 1986 (Erstauflage 1984), 242 Seiten, zahlreiche Abbildungen und Tabellen, Sachwortindex, SFr 54.00, ISBN 0‐87849‐523‐3Crystal Research and Technology, 1986
- The kinetics of precipitation from supersaturated solid solutionsJournal of Physics and Chemistry of Solids, 1961