Deflection Criteria for Numerical Assessment of the Sand Production Potential in an Openhole Completion
Authors:
- A. NouriANA. Nouri
- M. M. Al-DarbiMAM. M. Al-Darbi
- H. VaziriHVH. Vaziri
- M. R. IslamMIM. R. Islam
- 1 July 2002
- journal article
- research article
- Published by Taylor & Francis in Energy Sources
- Vol. 24 (7) , 685-702
Abstract
An elastic-plastic three-dimensional fully coupled model is proposed to model shear and tensile-induced sanding and consequently estimate volume of sand production. The problem is of significant interest to industry since a good estimation of wellface failure and therefore sand production helps the completion engineer to best design downhole completions. Such a design would not only maximize flow rate but also minimize cost of completion. In this investigation, a numerical analysis by using the finite difference method was performed. An elastic-plastic analysis by using the Mohr-Coulomb model was conducted. This model is indeed considered to be the most useful model for geotechnical analysis. For the purpose of this study, the openhole case was considered to have had large deformation and large plastic strains in order to determine the wellface failure and therefore sand production. Effective stress distributions around a wellbore were investigated. Based on this investigation, an effective way to model depletion-induced sanding is proposed. The effects of cohesion, friction angle, and modulus of elasticity as well as reservoir pressure on the critical bottom hole pressure were examined. The results show that the cohesion and the variation in friction angle affect the critical value of drawdown, the effect of the former one being more significant than the latter. Moreover, the modulus of elasticity and reservoir pressure affect the critical value of drawdown significantly. At higher values of the modulus of elasticity, however, the effect of the modulus of elasticity tapers off and a further increase in its value does not affect the critical value proportionally. The effect of the reservoir pressure on acceptable drawdown value indicates the effect of reservoir depletion on the potential of sand production.Keywords
This publication has 12 references indexed in Scilit:
- An analytical model for stability analysis of rock layers over a circular openingInternational Journal of Solids and Structures, 2001
- An erosion-mechanical model for sand production rate predictionInternational Journal of Rock Mechanics and Mining Sciences, 1998
- Evaluation of openhole cavity completion technique in coalbed methane reservoirsInternational Journal of Rock Mechanics and Mining Sciences, 1998
- Well-bore completion technique and geotechnical parameters influencing gas productionCanadian Geotechnical Journal, 1997
- Laboratory investigation of the mechanical behaviour of Tournemire shaleInternational Journal of Rock Mechanics and Mining Sciences, 1997
- Imaging of Sand Production in a Horizontal Sand Pack by X-Ray Computed TomographySPE Formation Evaluation, 1996
- Economical Management of Sand Production by a Methodology Validated on an Extensive Database of Field Data1995
- Analytical and numerical procedures for analysis of flow-induced cavitation in porous mediaComputers & Structures, 1995
- Fluid Flow and Sand Production in Heavy-Oil Reservoirs Under Solution-Gas DriveSPE Production Engineering, 1988
- Sand Stresses Around a WellboreSociety of Petroleum Engineers Journal, 1982