Biotribological properties of UHMWPE grafted with AA under lubrication as artificial joint
- 22 June 2013
- journal article
- research article
- Published by Springer Nature in Journal of Materials Science: Materials in Medicine
- Vol. 24 (9) , 2085-2091
Abstract
Osteolysis caused by wear particles from polyethylene in the artificial hip joints is a serious issue. In order to endow the low friction and wear of the bearing surface of ultra-high molecular weight polyethylene (UHMWPE) artificial joint for a longer term, hydrophilic acrylic acid (AA) was grafted on UHMWPE powders with the method of ultraviolet irradiation and then the modified powders were hot pressed. The tribological properties of modified UHMWPE sliding against CoCrMo metallic plate on reciprocating tribometer under calf serum, saline and distilled water lubrication during a long-term friction were investigated. The measurement of Fourier-transform infrared spectroscopy indicates that AA is successfully grafted on the surface of UHMWPE powders by photo-induced graft polymerization. Contact angles of UHMWPE are decreased from 83° to 35° by grafting and the surface wettability is effectively improved. The tensile strength of modified sample decreases. The friction coefficient and wear rate of UHMWPE-g-PAA under calf serum, saline and distilled water lubrication are lower than that of untreated UHMWPE. With the increase of grafting ratio, the wear rate of UHMWPE-g-PAA decreases firstly and then increases. The modified UHMWPE with grafting ratio of 3.5 % has the lowest wear rate, which is just quarter of the untreated UHMWPE. The hydrated PAA polymer brushes enclosed in the UHMWPE bulk material provide continuous lubrication during long term sliding.Keywords
This publication has 23 references indexed in Scilit:
- Cartilage-mimicking, High-density Brush Structure Improves Wear Resistance of Crosslinked Polyethylene: A Pilot StudyClinical Orthopaedics and Related Research, 2011
- Biocompatibility of Poly(Acrylic Acid) Thin Coatings Electro-synthesized onto TiAlV-based ImplantsJournal of Bioactive and Compatible Polymers, 2010
- Structure and Surface Properties of High‐density Polyelectrolyte Brushes at the Interface of Aqueous SolutionMacromolecular Symposia, 2009
- Notched stress–strain behavior of a conventional and a sequentially annealed highly crosslinked UHMWPEBiomaterials, 2008
- Cylindrical molecular brushes: Synthesis, characterization, and propertiesProgress in Polymer Science, 2008
- Enhanced wear resistance of orthopaedic bearing due to the cross‐linking of poly(MPC) graft chains induced by gamma‐ray irradiationJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2007
- Membrane-destabilizing polyanions: interaction with lipid bilayers and endosomal escape of biomacromoleculesAdvanced Drug Delivery Reviews, 2004
- Ultrafiltration membrane surfaces with grafted polymer ‘tentacles’: preparation, characterization and application for covalent protein bindingBiomaterials, 1998
- Microwave CO2 plasma-initiated vapour phase graft polymerization of acrylic acid onto polytetrafluoroethylene for immobilization of human thrombomodulinBiomaterials, 1997
- The Significance of Nonlinear Motion in the Wear Screening of Orthopaedic Implant MaterialsJournal of Testing and Evaluation, 1997