Corrosion resistance of stressed NiTi and stainless steel orthodontic wires in acid artificial saliva
- 8 August 2003
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part A
- Vol. 66A (4) , 829-839
Abstract
The purpose of this study was to investigate the corrosion resistance of stressed NiTi and stainless steel orthodontic wires using cyclic potentiodynamic and potentiostatic tests in acid artificial saliva at 37°C. An atomic force microscope was used to measure the 3‐D surface topography of as‐received wires. Scanning electron microscope observations were carried out before and after the cyclic potentiodynamic tests. The surface chemical analysis was characterized using X‐ray photoelectron spectroscopy and Auger electron spectroscopy after the potentiostatic tests. The cyclic potentiodynamic test results showed that the pH had a significant influence on the corrosion parameters of the stressed NiTi and stainless steel wires (p < 0.05). The pitting potential, protection potential, and passive range of stressed NiTi and stainless steel wires decreased on decreasing pH, whereas the passive current density increased on decreasing pH. The load had no significant influence on the above corrosion parameters (p > 0.05). For all pH and load conditions, stainless steel wire showed higher pitting potential and wider passive range than NiTi wire (p < 0.001), whereas NiTi wire had lower passive current density than stainless steel wire (p < 0.001). The corrosion resistance of the stressed NiTi and stainless steel wires was related to the surface characterizations, including surface defect and passive film. © 2003 Wiley Periodicals, Inc. J Biomed Mater Res 66A: 829–839, 2003Keywords
This publication has 24 references indexed in Scilit:
- Effect of chemical composition on the corrosion behavior of Ni‐Cr‐Mo dental casting alloysJournal of Biomedical Materials Research, 2002
- Bone modeling and cell–material interface responses induced by nickel–titanium shape memory alloy after periosteal implantationBiomaterials, 1999
- Electrochemical and surface characterization of a nickel–titanium alloyBiomaterials, 1998
- Nickel hypersensitivity in the orthodontic patientAmerican Journal of Orthodontics and Dentofacial Orthopedics, 1993
- The anodic dissolution and passivation of NiCrFe alloys studied by ESCACorrosion Science, 1992
- Reaction to Stainless Steel Wire Following Orthognathic SurgeryPlastic and Reconstructive Surgery, 1992
- In vivo measurement of anodic polarization of orthopaedic implant alloys: comparative study of in vivo and in vitro experimentsBiomaterials, 1989
- Effect of long-term immersion corrosion on the flexural properties of nitinolAmerican Journal of Orthodontics, 1982
- A Critical Appraisal of Some Popular Laboratory Electrochemical Tests for Predicting the Localized Corrosion Resistance of Stainless Alloys in Sea WaterCorrosion, 1972
- Corrosion-resistant alloys in chloride solutions: materials for surgical implantsProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1966