Study on the weld bead formation on square-groove butt joint using plasma-MIG hybrid welding process
Authors:
- 1 January 2020
- journal article
- research article
- Published by Japan Welding Society in QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
- Vol. 38 (2) , 135s-138s
Abstract
The welding with hybrid heat sources combined a plasma arc and a metal inert gas (MIG) arc was performed on the I-groove joint of 9 mm thick high-strength steel plates. The plasma torch is set up in the leading position, while the MIG torch is set up in the trailing position. As a result of observing hybrid welding with a high-speed camera, the plasma arc and the MIG arc are repelled each other. The influence of the root gap on the cross section and the bead formation was investigated. As a result, defect-free beads were formed at the root gap of 1.5 mm.Keywords
This publication has 4 references indexed in Scilit:
- High power disk laser-metal active gas arc hybrid welding of thick high tensile strength steel platesJournal of Laser Applications, 2015
- 3D Numerical Analysis Model for TIG-MIG Hybrid Welding ProcessQUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2012
- Research on Laser-arc Hybrid Welding of HT780 SteelQUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2011
- Single pass full penetration welding of high-tensile steel thick-plate using 4 kW fiber laser and MAG arc hybrid welding processQUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2009