Carbon Content and Grain Size Effects on the Sensitization of AISI Type 304 Stainless Steels
Authors:
- 1 January 1984
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 40 (1) , 21-32
Abstract
The sensitization domains of three AISI 304 austenitic stainless steels, differing only by their carbon content or grain size, have been determined using the ASTM A 262 Practice E and the EPR tests, in order to study the carbon content and grain size effects on sensitization kinetics in the temperature range 600 to 800 C. It has been found that increasing the grain size delays the beginning of the sensitization at the lower temperature considered in this study (600 C) and considerably delays desensitization. Decreasing the carbon content lowers the maximum temperature for sensitization (TK), but the discrepancies found between the results of the above-mentioned tests did not allow any other conclusion. As a consequence, the performance of these two tests has been compared, but some disagreements remain unexplained.Keywords
This publication has 5 references indexed in Scilit:
- Experimental Evaluation of a Metallurgical Model for Austenitic Stainless Steels SensitizationCorrosion, 1982
- Critical Cooling Rate of 18Cr-8Ni Stainless Steel for Sensitization and Subsequent Intergranular Stress Corrosion Cracking in High Temperature WaterCorrosion, 1978
- Low Temperature Sensitization of Welded Type 304 Stainless SteelCorrosion, 1978
- Continuous Cooling Sensitization of Type 304 Stainless SteelCorrosion, 1978
- Intergranular Stress Corrosion Cracking of Austenitic Stainless Steels in Oxygenated High Temperature WaterCorrosion, 1968