Measuring Glassy and Viscoelastic Polymer Flow in Molecular-Scale Gaps Using a Flat Punch Mechanical Probe
- 22 February 2008
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 2 (3) , 419-428
Abstract
This paper investigates molecular-scale polymer mechanical deformation during large-strain squeeze flow of polystyrene (PS) films, where the squeeze flow gap is close to the polymer radius of gyration (Rg). Stress–strain and creep relations were measured during flat punch indentation from an initial film thickness of 170 nm to a residual film thickness of 10 nm in the PS films, varying molecular weight (Mw) and deformation stress rate by over 2 orders of magnitude while temperatures ranged from 20 to 125 °C. In stress–strain curves exhibiting an elastic-to-plastic yield-like knee, the response was independent of Mw, as expected from bulk theory for glassy polymers. At high temperatures and long times sufficient to extinguish the yield-knee, the mechanical response Mw degeneracy was broken, but no molecular confinement effects were observed during thinning. Creep measurements in films of 44K Mw were well-approximated by bulk Newtonian no-slip flow predictions. For extrusions down to a film thickness of 10 nm, the mechanical relaxation in these polymer films scaled with temperature similar to Williams–Landel–Ferry scaling in bulk polymer. Films of 9000K Mw, extruded from an initial film thickness of 2Rg to a residual film thickness of 0.5Rg, while showing stress–strain viscoelastic response similar to that of films of 900K Mw, suggestive of shear-thinning behavior, could not be matched to a constitutive flow model. In general, loading rate and magnitude influenced subsequent creep extrusion depth of high-Mw films, with deeper final extrusions for high loading rates than for low loading rates. The measurements suggest that, for high-resolution nanoimprint lithography, mold flash or final residual film thickness can be reduced for high strain and strain rate loading of high-Mw thin films.Keywords
This publication has 50 references indexed in Scilit:
- Asymptotic solution to axisymmetric indentation of a compressible elastic thin filmThin Solid Films, 2006
- Impact of molecular weight of polymers and shear rate effects for nanoimprint lithographyMicroelectronic Engineering, 2006
- Choice of the molecular weight of an imprint polymer for hot embossing lithographyMicroelectronic Engineering, 2005
- Macromolecules at surfaces: Research challenges and opportunities from tribology to biologyJournal of Polymer Science Part B: Polymer Physics, 2003
- Local mass transport and its effect on global pattern replication during hot embossingMicroelectronic Engineering, 2003
- A detailed elastic analysis of the flat punch (tack) test for pressure-sensitive adhesivesJournal of Polymer Science Part B: Polymer Physics, 2000
- Polymer Mobility in Thin FilmsMacromolecules, 1996
- Nanorheology of Confined Polymer Melts. 3. Weakly Adsorbing SurfacesLangmuir, 1994
- Nanorheology of Confined Polymer Melts. 1. Linear Shear Response at Strongly Adsorbing SurfacesLangmuir, 1994
- Some correlations involving the shear viscosity of polystyrene meltsRheologica Acta, 1989