Experimental Analysis of a Slab Continuous-Casting SEN with an Inner Flow Divider
Authors:
- Jesus Gonzalez-TrejoJGJesus Gonzalez-Trejo
- J. Raul Miranda-TelloJMJ. Raul Miranda-Tello
- Francisco Cervantes-De-La-TorreFCFrancisco Cervantes-De-La-Torre
- Ignacio Carvajal-MariscalIgnacio Carvajal-Mariscal
- Florencio Sanchez-SilvaFSFlorencio Sanchez-Silva
- Ruslan GabbasovRGRuslan Gabbasov
- Cesar A. Real-RamirezCesar A. Real-Ramirez
Open Access
Abstract
In slab continuous-casting machines, the quality of the finished product mainly depends on the hydrodynamic behavior of the molten steel in the cavity of the continuous-casting mold, where the submerged entry nozzle is the central element. Recently, a nontraditional nozzle design was reported, where a solid barrier attached to the inner bottom wall of the nozzle divides its internal volume, particularly around the outlet ports. The solid barrier was named a flow divider. In this work, the effect of the flow divider is analyzed by comparing the performance of traditional nozzles with the performance of nozzles altered with the flow divider. The performance of the nozzles was evaluated experimentally, employing a scaled model of the mold section, using cold water as the working fluid. The shape of the nozzle outlet jets and the fluid flow pattern in the mold cavity were used to determine the performance of the nozzles. In addition, several factors affecting the process stability and the quality of the product were analyzed: the casting speed, the tilt of the nozzle outlet ports, and the injection of gas in the liquid stream entering the nozzle. The analysis showed that for the nozzles with the flow divider, (i) the outlet jets are narrow and symmetric, (ii) the symmetrical double-roll flow pattern in the mold cavity is obtained, (iii) the liquid-free surface is stable and has low distortions, and (iv) the flow divider neither increases the bubble breakage nor the coalescence between them.Keywords
Funding Information
- Universidad Autónoma Metropolitana (22703022, 22711777, SIP-20201315)
- PRODEP (22703022, 22711777, SIP-20201315)
- Instituto Politécnico Nacional (22703022, 22711777, SIP-20201315)
This publication has 29 references indexed in Scilit:
- Transient Internal Flow Characterization of a Bifurcated Submerged Entry NozzleISIJ International, 2006
- Water Model and CFD Studies of Bubble Dispersion and Inclusions Removal in Continuous Casting Mold of SteelISIJ International, 2006
- Experimental and Numerical Analysis of the Free Surface in a Water Model of a Slab Continuous Casting MoldISIJ International, 2005
- Mathematical modeling and optimization strategies (genetic algorithm and knowledge base) applied to the continuous casting of steelEngineering Applications of Artificial Intelligence, 2003
- Internal Defects of Continuous Casting Slabs Caused by Asymmetric Unbalanced Steel Flow in MoldISIJ International, 2003
- The use of a heuristic search technique for the optimization of quality of steel billets produced by continuous castingEngineering Applications of Artificial Intelligence, 2001
- A water model study of the flow asymmetry inside a continuous slab casting moldMetallurgical and Materials Transactions B, 1996
- Control of Immersion Nozzle Outlet Flow Pattern through the Use of Swirling Flow in Continuous Casting.ISIJ International, 1994
- Numerical analysis of fluid flow in continuous casting mold by bubble dispersion model.ISIJ International, 1991
- The effect of melt composition on solidification cracking of steel, with particular reference to continuous castingMetallurgical Transactions B, 1982