Mechanical and dielectric properties of porous and wave-transparent Si3N4-Si3N4 composite ceramics fabricated by 3D printing combined with chemical vapor infiltration
Authors:
Open Access
- 3 August 2019
- journal article
- research article
- Published by Tsinghua University Press in Journal of Advanced Ceramics
- Vol. 8 (3) , 399-407
Abstract
Porous Si3N4-Si3N4 composite ceramics were fabricated by 3D printing combined with low-pressure chemical vapor infiltration (CVI). This technique could effectively improve the designability of porous Si3N4 ceramics and optimize the mechanical and dielectric properties. The effects of process parameters including the deposition time and heat treatment on the microstructure and properties of porous Si3N4-Si3N4 composite ceramics were studied. The study highlights following: When CVI processing time was increased from 0 to 12 h, the porosity decreased from 68.65% to 26.07% and the density increased from 0.99 to 2.02 g/cm3. At the same time, the dielectric constant gradually increased from 1.72 to 3.60; however, the dielectric loss always remained less than 0.01, indicating the excellent electromagnetic (EM) wave-transparent performance of porous Si3N4-Si3N4 composite ceramics. The maximum flexural strength of 47±2 MPa was achieved when the deposition time attained 6 h. After heat treatment, the porosity increased from 26.07% to 36.02% and the dielectric constant got a slight increase from 3.60 to 3.70 with the dielectric loss still maintaining lower than 0.01. It has been demonstrated that the porous Si3N4-Si3N4 composite ceramics are a promising structural and EM wave-transparent material suitable for high temperature service.Keywords
This publication has 17 references indexed in Scilit:
- Modeling for high-temperature dielectric behavior of multilayer C /Si3N4 composites in X-bandJournal of the European Ceramic Society, 2017
- Effect of chemical vapor deposition of Si3N4, BN and B4C coatings on the mechanical and dielectric properties of porous Si3N4 ceramicScripta Materialia, 2012
- Preparation and properties of pressureless-sintered porous Si3N4Journal of Materials Science, 2010
- Effect of monomer content on physical properties of silicon nitride ceramic green body prepared by gelcastingCeramics International, 2009
- Oxidation bonding of porous silicon nitride ceramics with high strength and low dielectric constantMaterials Letters, 2007
- Three‐dimensional printing of porous ceramic scaffolds for bone tissue engineeringJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005
- Defects and prevention in ceramic components fabricated by inkjet printingJournal of Materials Processing Technology, 2004
- Design, preparation and properties of non-oxide CMCs for application in engines and nuclear reactors: an overviewComposites Science and Technology, 2004
- The computer aided manufacture of ceramics using multilayer jet printingJournal of Materials Science Letters, 1995
- Si3N4 and Si2N2O for high performance radomesMaterials Science and Engineering, 1985