Influence of the indenter tip geometry and environment on the indentation modulus of enamel
- 1 March 2009
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 24 (3) , 616-625
Abstract
The aim of the investigation was to study the influence of indenter tip geometry on the conventionally obtained indentation modulus of enamel by nanoindentation. Indentation tests on bovine enamel using three different diamond pyramidal indenters with half face angles 65.27°, 45°, and 35.26° were conducted to evaluate the indentation modulus using the Oliver–Pharr method [W.C. Oliver and G.M. Pharr,J. Mater. Res.7,1564 (1992)]. In addition, three different dehydration conditions were studied: wet under Hank's balanced salt solution, laboratory dried, and vacuum dehydrated. For the Berkovich indenter (65.27°) and 45° pyramidal indenters, there was only a small difference between indentation modulus values, whereas for the cube-corner indenter (35.26°) a ratio of 2.4 between laboratory dry and wet samples was found. A detailed evaluation, including indentation creep and recovery as well as pileup, resulted in a reduction of this latter ratio to 1.7. This still large difference was rationalized on the basis of the different deformation mechanisms generated by indenters of different face angles.Keywords
This publication has 31 references indexed in Scilit:
- The effect of prism orientation on the indentation testing of human molar enamelArchives of Oral Biology, 2007
- Contact induced deformation of enamelApplied Physics Letters, 2007
- Nanoindentation of bone: Comparison of specimens tested in liquid and embedded in polymethylmethacrylateJournal of Materials Research, 2004
- Sharp probes of varying acuity: Instrumented indentation and fracture behaviorJournal of Materials Research, 2004
- Determination of fracture toughness from the extra penetration produced by indentation-induced pop-inJournal of Materials Research, 2003
- Determination of Elastic Modulus of Dentin by Small Spherical Diamond Indenters.Dental Materials Journal, 2001
- Determining the mechanical properties of small volumes of material from submicrometer spherical indentationsJournal of Materials Research, 1995
- Spherical indentation of tooth enamelJournal of Materials Science, 1981
- The indentation of materials by wedgesProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1969
- The relation between load and penetration in the axisymmetric boussinesq problem for a punch of arbitrary profileInternational Journal of Engineering Science, 1965