Rheological properties of alumina injection feedstocks
Open Access
- 1 June 2005
- journal article
- Published by FapUNIFESP (SciELO) in Materials Research
- Vol. 8 (2) , 187-189
Abstract
The rheological behavior of alumina molding feedstocks containing polyethylene glycol (PEG), polyvinylbutyral (PVB) and stearic acid (SA) and having different powder loads were analyzed using a capillary rheometer. Some of the feedstocks showed a pseudoplastic behavior of n < 0, which can lead to the appearance of weld lines on molded parts. Their viscosity also displayed a strong dependence on the shear rate. The slip phenomenon, which can cause an unsteady front flow, was also observed. The results indicate that the feedstock containing a lower powder load displayed the best rheological behavior. The 55 vol. % powder loaded feedstock presented the best rheological behavior, thus appearing to be more suitable than the formulation containing a vol. 59% powder load, which attained viscosities exceeding 10³ Pa.s at low shear rates, indicating its unsuitability for injection moldingKeywords
This publication has 4 references indexed in Scilit:
- Mixing and characterization of feedstock for powder injection moldingMaterials Letters, 2000
- Slip flow in concentrated alumina suspensionsPowder Technology, 1998
- Rheological behaviour of a polymer ceramic blendJournal of the European Ceramic Society, 1997
- Systematic development of the ceramic injection moulding processMaterials Science and Engineering: A, 1989