Tensile and Compressive Strength of Silica Fume-Cement Pastes and Mortars
Authors:
- 1 December 1996
- journal article
- Published by ASTM International in Cement, Concrete and Aggregates
- Vol. 18 (2) , 78-84
Abstract
The effect of silica fume on the compressive and uniaxial direct tensile strength of portland cement paste and mortar is reported. Sixteen and 25% of the cement used in the paste and in the mortar, measured by mass, was replaced by silica fume. Four different W/C ratio mixtures were tested: 0.22, 0.25, 0.28, and 0.31. The super-plasticizer content was adjusted for each mixture to provide a sufficient amount for efficient dispersion of the cement and silica fume particles, but also to make sure that there would be no excess of this additive that might lead to effects such as bleeding. Results show that the partial replacement of cement by silica fume increases the compressive strength of mortar but has no effect on the compressive strength of paste. Results also show that the partial replacement of portland cement by silica fume decreases the tensile strength of both paste and mortar. The reduction in the strength of paste was greater than the reduction in the strength of mortar. Results were verified by statistical analysis using hypothesis testing at a 95% confidence level. The uniaxial tensile strength results were obtained using the cementitious composites axial tensile technique (CCATT). The relation between the tensile strength and compressive strength of materials with and without silica fume was obtained. The ratios of tensile to compressive strength of paste and of mortar were decreased with increasing silica fume content.Keywords
This publication has 17 references indexed in Scilit:
- Room temperature tensile and flexural strength of ceramics in AlN-SiC systemJournal of the European Ceramic Society, 1995
- Effect of matrix composition on the aging of CFRCCement and Concrete Composites, 1995
- Uniaxial Tensile Strength of Cementitious CompositesJournal of Testing and Evaluation, 1994
- Behaviour of carbon fiber reinforced cement composites in direct tensionCement and Concrete Research, 1993
- Room Temperature Tensile Strength of Ain1993
- Tensile Strength of Carbon Fiber Reinforced Cement CompositesMRS Proceedings, 1991
- Curing Effects, Strength and Physical Properties of High Strength Silica Fume ConcretesJournal of Materials in Civil Engineering, 1989
- Discussion: Application of the highly stressed volume approach to correlated results from different tensile tests of concreteMagazine of Concrete Research, 1986
- Properties of portland cement-silica fume pastes I. Porosity and surface propertiesCement and Concrete Research, 1985
- Alignment Problems in the Tensile TestJournal of Testing and Evaluation, 1976