Towards Highly Stable Storage of Sodium Ions: A Porous Na3V2(PO4)3/C Cathode Material for Sodium‐Ion Batteries
- 6 September 2013
- journal article
- research article
- Published by Wiley in Chemistry – A European Journal
- Vol. 19 (43) , 14712-14718
Abstract
A porous Na3V2(PO4)3 cathode material coated uniformly with a layer of approximately 6 nm carbon has been synthesized by the sol–gel method combined with a freeze‐drying process. The special porous morphology and structure significantly increases the specific surface area of the material, which greatly enlarges the contact area between the electrode and electrolyte, and consequently supplies more active sites for sodium ions. When employed as a cathode material of sodium‐ion batteries, this porous Na3V2(PO4)3/C exhibits excellent rate performance and cycling stability; for instance, it shows quite a flat potential plateau at 3.4 V in the potential window of 2.7–4.0 V versus Na+/Na and delivers an initial capacity as high as 118.9 and 98.0 mA h g−1 at current rates of 0.05 and 0.5 C, respectively, and after 50 cycles, a good capacity retention of 92.7 and 93.6 % are maintained. Moreover, even when the discharge current density is increased to 5 C (590 mA g−1), an initial capacity of 97.6 mA h g−1 can still be achieved, and an exciting capacity retention of 88.6 % is obtained after 100 cycles. The good cycle performance, excellent rate capability, and moreover, the low cost of Na3V2(PO4)3/C suggest that this material is a promising cathode for large‐scale sodium‐ion rechargeable batteries.Keywords
This publication has 39 references indexed in Scilit:
- Electrode Materials for Rechargeable Sodium‐Ion Batteries: Potential Alternatives to Current Lithium‐Ion BatteriesAdvanced Energy Materials, 2012
- Na-ion batteries, recent advances and present challenges to become low cost energy storage systemsEnergy & Environmental Science, 2012
- Electrochemical and Thermal Properties of NASICON Structured Na3V2(PO4)3as a Sodium Rechargeable Battery Cathode: A Combined Experimental and Theoretical StudyJournal of the Electrochemical Society, 2012
- Li–O2 and Li–S batteries with high energy storageNature Materials, 2011
- Carbon-coated nano-sized Li4Ti5O12 nanoporous micro-sphere as anode material for high-rate lithium-ion batteriesEnergy & Environmental Science, 2011
- Voltage, stability and diffusion barrier differences between sodium-ion and lithium-ion intercalation materialsEnergy & Environmental Science, 2011
- A new type rechargeable lithium battery based on a Cu-cathodeElectrochemistry Communications, 2009
- A Polyaniline‐Intercalated Layered Manganese Oxide Nanocomposite Prepared by an Inorganic/Organic Interface Reaction and Its High Electrochemical Performance for Li StorageAdvanced Materials, 2008
- Building better batteriesNature, 2008
- Issues and challenges facing rechargeable lithium batteriesNature, 2001