On–off and proportional–integral controller for a morphing wing. Part 1: Actuation mechanism and control design
- 21 November 2011
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 226 (2) , 131-145
Abstract
The main objective of this research work is the development of an actuation control concept for a new morphing actuation mechanism made of smart materials, which is built from a shape memory alloy (SMA). Two lines of smart actuators were incorporated to a rectangular wing to modify the upper wing surface, made of a flexible skin, with the intention to move the laminar-to-turbulent transition point closer to the wing trailing edge. After a brief introduction of the morphing wing system architecture and requirements, the actuation lines' design and instrumentation are presented. The integrated controller controls the SMA actuators via an electrical current supply, so that the transducer position can be used to eliminate the deviation between the required values for vertical displacements (corresponding to the optimized airfoils) and their physical values. The final configuration of the integrated controller is a combination of a bi-positional (on–off) controller and a PI (proportional–integral) controller, due to the two heating and cooling phases of the SMA wires' interconnection. This controller must behave like a switch between the cooling and the heating phases, situations where the output current is 0 A, or is controlled by a PI type law. The PI controller for the heating phase is optimally tuned using integral and surface minimum error criteria (Ziegler–Nichols). The controller is numerically tested on the linear identified system in terms of time response, Bode diagram, amplitude and phase stability margins, and root-locus.Keywords
This publication has 9 references indexed in Scilit:
- Design of Shape Memory Alloy Actuators for Morphing Laminar Wing With Flexible ExtradosJournal of Mechanical Design, 2009
- Adaptive neuro-fuzzy inference system-based controllers for smart material actuator modellingProceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 2009
- Closed-Loop Control Simulations on a Morphing WingJournal of Aircraft, 2008
- Shape Control of a FRP Airfoil Structure Using SMA-Actuators and Optical Fiber SensorsSolid State Phenomena, 2008
- Morphing skinsThe Aeronautical Journal, 2008
- Non-isothermal finite element modeling of a shape memory alloy actuator using ANSYSComputational Materials Science, 2006
- Design and application of compliant mechanisms for morphing aircraft structures2003
- Review of State of Art of Smart Structures and Integrated SystemsAIAA Journal, 2002
- Navier-Stokes investigation of blunt trailing-edge airfoils using O gridsJournal of Aircraft, 1993